Ampacity - Study guides, Class notes & Summaries

What is the result if the neutral wire becomes open on a multiwire circuit having unequal loads? Select one: a. The load of higher resistance would overheat and probably be damaged. b. The load of lesser resistance would overheat and probably be damaged. c. No effect until one load is turned off or opens. d. No effect. The load of higher resistance would overheat and probably be damaged. Refer to Figure 128.202. ___ volts are applied across the water heater element. S...

NEIEP 500 Final Exam Version 1 (Latest 2023/ 2024 Update) Questions and Verified Answers| 100% Correct| Grade A Q: How are wire sizes larger than 4/0 measured? Answer: In circular mils Q: What is the abbreviated term for current carry8ing capacity? Answer: Ampacity Q: What is the minimum size wired for lighting circuits in an elevator installation? Answer: #14 Q: What is the special about wire used for the interlock circuit? Answer: It must be rate...

Ampacity - ANSWER The maximum current, in amperes, that a conductor can carry continuously under the conditions of use without exceeding its temperature rating. Bonded (Bonding) - ANSWER Connected to establish electrical continuity and conductivity. Bonding Jumper, Main - ANSWER The connection between the grounded circuit conductor and the equipment grounding conductor at the service.

According to the NEC®, the ampacity of branch circuit conductors must be derated when there are more than how many current-carrying conductors in a raceway? - correct answer 3 Air conditioning overcurrent protective devices can never exceed what percentage of the motor-rated load current or the branch circuit selection current (whichever is greater)? - correct answer 225% Conductors must be derated when installed in conduit - correct answer on or above rooftops Continuous loads are cal...

NABCEP PV ASSOCIATE EXAM QUESTIONS & ANSWERS 2023/2024 An off-grid installation has a 1HP pump that is on 10% of the time and a 20W light that is on 100% of the time. What is the monthly energy use? - ANSWER-68KWh 1HP = 746W 746W * 0.1 * 24hours * 30days = 53712Wh 20W * 24hrs * 30days = 14400Wh 14400 + 53712 = 68112Wh 68kWh What kind of ground faults do most inverters detect? - ANSWER-DC Inverters detect dc ground faults. AC ground faults are detected on the AC side of the inverter a...

Master Electrical REAL Exam Questions And Correct Answers | Verified Control the speed of the motor - ANSWER The purpose of having a rheostat in the field of a DC shunt motor is to ________. An ammeter, a wattmeter, and a voltmeter - ANSWER You are to check the power factor of a load, you cannot get a power factor meter, you would use__________. Lead sheath - ANSWER High voltage cable which is to be installed in underground ducts is generally protected with a __________. Lower watt...

Load calculation Feeders and services Level 4 Module 1 Questions with 100% Correct Answers | Latest Version 2024 | Verified What is the demand factor allowed by the NEC® for calculating the neutral conductor size for electric range load? - 70% Using the VA/linear foot method, the total VA that must be used in a service calculation for a 50' show window is - 12,500VA Before it is considered a continuous load, a load must operate for at least how many hours without interruption? - 3 ...

Electrical Level 3 Module 1 Load Calculations and Branch Feeder Circuits Quiz_ 2022. According to the NEC®, the ampacity of branch circuit conductors must be derated when there are more than how many current-carrying conductors in a raceway? Air conditioning overcurrent protective devices can never exceed what percentage of the motor-rated load current or the branch circuit selection current (whichever is greater)? Conductors must be derated when installed in conduit Continuous load...

NEC Exam prep questions and answers, graded A+ There are six conductors in a raceway connected to 75 degree Celsius rated breakers. Each wire has a 70 amp load using THHN conductors. The minimum size conductors used are #_________AWG. A. 4 B. 6 C. 8 D. 10 A. #4 60 degree column (110.14(C)) adjust from 90 degree column 95 x .8 = 76a Thermal insulation shall not be installed within __________ inches of recessed fixtures. A. 1/2 B. 3/4 C. 2 D. 3 D. 3 410.116(B) Brainpower Read ...

ELECTRICAL CODE CALCULATIONS LVL 1 LESSON 2 - DETERMINING CONDUCTOR AMPACITY -25