100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
Journeyman Electrician Practice Test With Solutions 100% Solved $22.49   Add to cart

Exam (elaborations)

Journeyman Electrician Practice Test With Solutions 100% Solved

 2 views  0 purchase
  • Course
  • JOURNEYMAN ELECTRICIAN
  • Institution
  • JOURNEYMAN ELECTRICIAN

Journeyman Electrician Practice Test With Solutions 100% Solved To find the full-load current rating of the single-phase transformer apply the single-phase current formula as shown:I = (150 kVA x 1000) / 240 volts = 15,000/240 = 625 amperes Which one of the following listed circuit breakers i...

[Show more]

Preview 3 out of 21  pages

  • October 5, 2024
  • 21
  • 2024/2025
  • Exam (elaborations)
  • Questions & answers
  • JOURNEYMAN ELECTRICIAN
  • JOURNEYMAN ELECTRICIAN
avatar-seller
UpperClass
Journeyman Electrician Practice Test With
Solutions 100% Solved

To find the full-load current rating of the single-phase transformer apply the single-phase current

formula as shown:I = (150 kVA x 1000) / 240 volts = 15,000/240 = 625 amperes




Which one of the following listed circuit breakers is NOT a standard ampere rating? 75

amperes




the standard ampere ratings for fuses and circuit breakers. A circuit breaker with an ampere

rating of 75 amperes is not a standard ampere rating.




The MINIMUM length of free conductor to be left at each junction box for the purpose of

splicing conductors, or making connections to illuminares or devices shall be _____ . 6

inches




free conductor is to be left at each junction box for splices or the connection of luminaires or

devices. The intent of this rule is to ensure enough conductor slack for the terminal connections

or splices to be made easily.

, Journeyman Electrician Practice Test With
Solutions 100% Solved
In general, overhead service-drop conductors shall NOT be smaller than _____. 8 AWG

copper




overhead service-drop conductors to be not smaller than 8 AWG copper or 6 AWG aluminum or

copper-clad aluminum. Do not get service-drop conductors, the overhead conductors between the

utility electric supply system and the service point, confused with the service-entrance

conductors, the conductors from the service point from the utility company to the service

disconnecting means.




When a galvanized eye-bolt is to be used as the point of attachment for an electrical service, the

NEC requires the eye-bolt to be installed NOT less than _____ above finished grade. 10

ft.




provide adequate vertical clearance of the conductors and prevent physical damage to the

conductors and prevent persons from making accidental contact with the conductors which may

create a shock hazard or electrocution. In no case shall the point of attachment of the service-

drop conductors to be less than 10 ft. above finished grade.




Why is electrical continuity required for metallic conduit? To establish an effective

ground-fault path and facilitate the operation of the over-current protective device.

, Journeyman Electrician Practice Test With
Solutions 100% Solved

Electrical continuity is required for metallic conduit to establish an effective ground-fault path

and facilitate the operation of the overcurrent protective device.




In dwelling units, receptacle outlets installed for countertop surfaces, must be located above, but

NOT more than _____ above the countertop or work surface. 20 inches




receptacle outlets installed for countertop or work surfaces in dwelling units may be located on

or above, but not more than 20 in. above the countertop or work surface. The intent of this rule is

to eliminate the use of unsightly extension cords (which reduces the amount of usable countertop

space) on the countertop or work surface to supply cord-and-plug connected appliances. Also,

receptacles located more than 20 inches above countertops or work surfaces may interfere with

the cabinetry to be installed.




When conductors are installed in a conduit or tubing nipple of _____ or less in length, the

ampacity adjustment factors for more than three (3) current-carrying conductors in the raceway,

are not required to be applied. 24 inches




adjustment factors for more than three (3) current-carrying conductors in raceways shall not

apply where the raceway is not more than 24 inches in length. Where more than 3 current-

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller UpperClass. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for $22.49. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

79276 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy study notes for 14 years now

Start selling
$22.49
  • (0)
  Add to cart