ASE Bundled Exams:::Questions and Answers | 100% Correct

ASE: Steering and Suspension Practice Exam Questions and Answers How would you adjust a rack yoke bearing? - Answer️️ -Tighten, then look at OEM specifications and back off by the suggested amount of degrees. If a customer states that their steering wheel turns more to the left than to the...

ASE A6 Electrical/Electronic Systems Practice Exam Questions and Answers An air bag system is being serviced, Technician A says to disconnect the yellow SRS connectors at the front of the vehicle. Technician B says to disconnect and isolate the negative battery cable. Who is right? A. Technic...

ASE Brakes A5 Test ( Exam 2 ) Practice Questions and Answers The brakes are dragging on a vehicle. this could be cause by a. overfilled master cylinder reservoir b. low vacuum to the boost c. bypassing master cylinder d. quick take-up valve stuck open - Answer️️ -A : overfilled master cyl...

Non structural analysis and body repairs ASE Exam Practice Questions and Answers (100% Pass) Outer bodies - Answer️️ -Form the exterior panels What outer bodies are usually bolted on? - Answer️️ -Fenders doors, hoods and deck lids What outer bodies are usually welded or bonded on? - An...

Diesel Tech Suspension and Steering ASE Exam Practice Test 6 Questions and Answers What is the LEAST LIKELY condition that improper wheel balance would cause? A. Cupped tire tread wear B. Vibration while braking C. Wheel hop or tramp D. Wheel shimmy - Answer️️ -B. Vibration while braking ...

ASE S4 Brakes Exam Practice Questions and Answers The air system is maintained at what pressure? - Answer️️ -100 to 120 pounds per square inch. At what pressure does the low pressure switch activate? - Answer️️ -Below 60 pounds per square inch. A safety or pop off valve is usually insta...

Ase G1 Exam Practice Questions and Answers (100% Pass) While road testing a vehicle, a technician verifies the customer's complaint of steering wheel shimmy durning hard braking. The Technician Should: A. Tell the vehicle owner. B. Tell the shop supervisor. C. Tell the shop manager. D. Note...

ASE Auto Maintenance & Light Repair Test (Test G1) Practice Questions and Answers A tight timing belt makes what type of noise? - Answer️️ -Whining A RWD (rear wheel drive) transmission has a leaking output shaft seal on a vehicle with 25,000 miles on the odometer. The MOST likely cause for...

Automotive Collision ASE Practice Exam Practice Questions and Answers Technician A says that when replacing metal parts, an anti- corosion material should be applied. Technician B says that some adhesive products may contain anti-corrosion properties. Who is right? A. A only B. B only C. Bot...

ase exam practice questions and answers A technician is performing a load test on a battery and finds the battery to below specifications. Which of the following is the best action to taken next? a Perform a resistance test on the battery b Recharge the battery and sell it as a used battery c R...

4. ASE Test A4, Section D - Wheel and Tire Diagnosis and Service Practice Questions and Answers What will cause feathered tire wear? - Answer️️ -Improper toe adjustment. What causes wear on the inner or outer side of the tire tread face? - Answer️️ -Improper camber adjustment. What ca...

ASE (Entry level technician prep) - Brakes A5 Exam Practice Questions and Answers (100% Pass) A5 Question 1 The brake pedal is low and spongy; all brake adjustments have been completed according to specifications. The cause of the problem could be: A) Binding pedal linkage. B)Dented brake lin...

ASE G1 Maintenance and Lt. Repair Practice Test Questions and Answers (100% Pass)

ASE A3 Exam Study Guide with Complete Solutions Noise: In gear, clutch disengaged (pedal to floor) - Answer️️ -Pilot bushing or bearing Noise: Neutral, clutch disengaged (pedal to floor) - Answer️️ - Release bearing Noise: Neutral, clutch engaged (pedal up) - Answer️️ -Input shaft ...

Complete ASE Practice Test 3 (Lubrication and Cooling Systems Diagnosis and Repair) "Engine Block Diagnosis and Repair" (page 68 to 75) from ASE A1 Practice Study Guide with Complete Solutions Technician A says that before installing an oil pump, it should be primed with clean engine oil. Tech...