Nate gas furnace - Study guides, Class notes & Summaries

NATE Gas Furnace Service Exam Latest Update...

What is the typical load rating of the branch circuit over-current protection for a residential gas furnace? - Answer-25 Amp What is recommended for a pressurization leak test of fuel gas pipe? - Answer-Compressed air When selecting a replacement indoor blower motor, Which criteria should be included? - Answer-Motor horsepower Induced draft blowers in direct vent condensing furnaces pull combustion air from: - Answer-Outdoors only What is the primary purpose of an off delay timer in ...

What precautions, if any, must be taken when installing a gas furnace on a wooden platform in an attic? - Answer- Use a zero-clearance furnace or add a non-combustible base A vent connector should have a as few elbows and joints as possible to: - Answer- Reduce resistance of flue gases The gas control valve may be damaged if exposed to an inlet pressure above - Answer- 14in wc To which thermostat is leveling the most critical: - Answer- Mercury Bulb Which of the following is a reason...

NATE Gas Furnace Service 117 Questions with Correct Answers 100% Verified What is the typical load rating of the branch circuit over-current protection for a residential gas furnace? - Correct Answer 25 Amp What is recommended for a pressurization leak test of fuel gas pipe? - Correct Answer Compressed air When selecting a replacement indoor blower motor, Which criteria should be included? - Correct Answer Motor horsepower Induced draft blowers in direct vent condensing furnaces pull c...

What precautions, if any, must be taken when installing a gas furnace on a wooden platform in an attic? Correct Answer Use a zero-clearance furnace or add a non-combustible base A vent connector should have a as few elbows and joints as possible to: Correct Answer Reduce resistance of flue gases The gas control valve may be damaged if exposed to an inlet pressure above Correct Answer 14in wc To which thermostat is leveling the most critical: Correct Answer Mercury Bulb Which of the f...

NATE Gas Heating Exam Verified Questions and answers 2023 Latest Update Since 1992, the United States Department of Energy has required that all furnaces sold and installed from that date on must have an AFUE of no less than: A: 70% B: 75% C: 78% D: 80% - correct answer C: 78% Many pre-1992 furnaces have efficiencies around . A: 10% B: 40% C: 60% D: 80% - correct answer C: 60% Today, furnaces with AFUE ratings greater than are available. A: 85% B: 90% C: 100% D: 110% - correct ...

HVAC NATE Gas Heat Exam Prep (Latest 2024 / 2025 Update) 100% Correct Questions and Verified Answers | Grade A Question: Differential pressure gauge (also called a manometer) is used to... Answer: Measure duct static pressure Question: A line voltage fuse is used to protect from... Answer: Excessive voltage Question: Forced air residential/ light commercial gas furnaces provide heat by... Answer: Circulating air across the heat exchanger Question: No mechanical fasten...

HVAC NATE Gas Heat Exam Prep (Latest 2024/ 2025 Update) 100% Correct Questions and Verified Answers| Grade A Q: When starting up a dual system, the temperature rise method for determining airflow cannot be used with compressor cycle of the heat pump because: Answer: The capacity of the system varies too much with outdoor temperature. Q: The flame pattern a technician would expect to see on a properly operating single stage gas furnace equipped with "in shot" type burner is a:...

HVAC NATE Gas Heat Exam (New 2024/ 2025 Update) Questions and Verified Answers 100% Correct | A Grade QUESTION A damaged section of double wall vent pipe is to be replaced with a section produced by a different manufacturer: Answer: The installer should check the new section for compatible locking joints. QUESTION If too much primary air is used the flame will: Answer: Lift off the burner. QUESTION What is the problem when a flame on a high efficien...