Ase brakes exam - Study guides, Class notes & Summaries

ASE A5 Brakes Exam Questions and Answers 2024.

Michigan ASE Brake Certification Exam Questions And Answers (Verified And Updated) Air in Hydraulic System - answerA spongy brake pedal may be caused by Excessive tire pressure - answerCan not cause very erratic brake pulling while applying brakes Excessive brake pedal travel - answerA power assist brake booster push rod that is too short will cause Brake drum machined beyond its limits - answerCan cause brake pedal fade Repair leak and replace brake linings - answerHow to correctly ser...

ASE BRAKES Exam Complete Questions and Answers 2024 Latest Edition

ASE BRAKES Exam #1 Questions and Answers (Latest Update 2024)

T4 ASE Brakes Exam with complete Graded A+ solutions Psi loss rate for Straight Truck 2 psi/minute Psi loss rate for combination vehicle less than 3 psi/minute Service Brake Pressure Drop Test Apply service brake to 90 psi. Loss rate should be less than 3 psi/minute for straight vehicles and less than 4 psi/minute for combination vehicles. Improperly adjusted brake shoes Cause 1) brake imbalance 2) increased stopping distance 3) excessive heat and wear Instability a...

The brake fluid reservoir is low on fluid. Which of the following is the most likely cause? A. Worn pads B. Worn shoes C. Bypassing master cylinder D. Leaking vacuum check valve (Ans- A A customer says their car makes more noise on asphalt than on concrete road surfaces. Which of the following could be the cause? A. Front wheel bearing wear B. Rear wheel bearing wear C. Aggressive tire treat patterns D. Worn brake pads (Ans- C Which of the following would most likely cause a brake ...

ASE BRAKES Exam #4 – Questions & Correct Answers

ASE BRAKES Exam #1|Complete Answers Graded A+ A A drum is chattering on the brake lathe. This could be the result of: A. Failure to install the dampening belt. B. Cutting too slowly. C. Dull cutting blades. D. Cutting speed too fast. C A vehicle is equipped with a hydro-boost brake system has a hard pedal with little braking action. Which of the following could be the cause? A. Low brake fluid B. Air in the brake fluid C. Low power steering fluid D. An overtightened power steerin...

drum is chattering on the brake lathe. This could be the result of: A missing dampening belt could cause the drum to vibrate while on the lathe. This vibration can cause the drum to bounce on the cutting tip and make a chattering noise. A vehicle equipped with a hydro-boost brake system has a hard pedal with little braking action. Which of the following could be the cause? Low power steering fluid can cause the booster to provide very little if any boost. 10 Must-Have Accessories for...

Disc brakes use replaceable friction material called __________. - Answer- Pads Drum brakes use replaceable friction material called ________. - Answer- Shoes Technician A says that a power-assisted brake reduces stopping distances compared with a non-power-assisted brake system. Technician B says that the power-assisted brake system reduces the force that the driver must exert on the brake pedal. Which technician is correct? - Answer- Technician B only A locked wheel __________________...