Smoke dampers - Study guides, Class notes & Summaries

ASE G1 Questions and Answers A tight timing belt makes what type of noise? - Answer ️️ -Whining A RWD (rear wheel drive) transmission has a leaking output shaft seal on a vehicle with 25,000 miles on the odometer. The MOST likely cause for the leakage is: - Answer ️️ -Plugged Transmission Breather filter Of the following, when replacing a CV (constant velocity) joint or boot, what is the last step before clamping the boot? - Answer ️️ -Burping Steering dampers can be used to r...

ASE G1 Questions and Answers A tight timing belt makes what type of noise? - Answer ️️ -Whining A RWD (rear wheel drive) transmission has a leaking output shaft seal on a vehicle with 25,000 miles on the odometer. The MOST likely cause for the leakage is: - Answer ️️ -Plugged Transmission Breather filter Of the following, when replacing a CV (constant velocity) joint or boot, what is the last step before clamping the boot? - Answer ️️ -Burping Steering dampers can be used to r...

ASE G1 Questions and Answers A tight timing belt makes what type of noise? - Answer ️️ -Whining A RWD (rear wheel drive) transmission has a leaking output shaft seal on a vehicle with 25,000 miles on the odometer. The MOST likely cause for the leakage is: - Answer ️️ -Plugged Transmission Breather filter Of the following, when replacing a CV (constant velocity) joint or boot, what is the last step before clamping the boot? - Answer ️️ -Burping Steering dampers can be used to r...

A tight timing belt makes what type of noise? - ANSWER-Whining A RWD (rear wheel drive) transmission has a leaking output shaft seal on a vehicle with 25,000 miles on the odometer. The MOST likely cause for the leakage is: - ANSWER-Plugged Transmission Breather filter Of the following, when replacing a CV (constant velocity) joint or boot, what is the last step before clamping the boot? - ANSWER-Burping Steering dampers can be used to reduce excessive __________. - ANSWER-positive caste...

CSIA Certification Questions & Answers | 100% Correct Answers | Verified | Latest 2024 Version Draft is measured by... - inches in water column Definition of Draft - Difference of pressure INSIDE and OUTSIDE the venting system Easiest solution to "back puffing" stove? - Give it more air What has the greatest effect on FLOW? - Size of venting system passageway A masonry chimney is required by what to have a cleanout if the flue previously vented a solid or liquid fuel applia...

CSIA Certification Exam (Updated) Question With Completed Answers. Draft is measured by... -Answer-inches in water column Definition of Draft -Answer-Difference of pressure INSIDE and OUTSIDE the venting system Easiest solution to "back puffing" stove? -Answer-Give it more air What has the greatest effect on FLOW? -Answer-Size of venting system passageway A masonry chimney is required by what to have a cleanout if the flue previously vented a solid or liquid fuel appliance? -Answer-NFPA...

HVAC Journeyman's Study Set Exam Final Questions and Answers The maximum horizontal length of a single-wall connector shall be ____ percent of the height of the chimney or vent. - CORRECT ANSWER-75% Grease filters shall be installed at an angle of not less that ____ degrees from the horizontal and shall be equipped with a drip tray beneath the lower edge of the filters - CORRECT ANSWER-45 A device that will automatically shut off the fuel supply to a main burner or group of burners ...

FIRE ALARM QUESTIONS AND ANSWERS GRADED A+ Spot type smoke detectors located on a sidewall shall be located between _____ and _____ inches down from the ceiling to the top of the detector 4 and 12 The secondary power source for a fire alarm may be a battery with enough capacity to support the fire alarm panel with enough power to last ? hours, after which it shall have enough capacity to sound the notification appliances for at least? minutes 24 hours, 5 minutes Partitions which...

Types of Fire Alarms and Detection Systems Questions and Answers Latest Updated What factors and conditions associated with the use and occupancy of a building determine the requirements to install manual fire alarm and detection systems? Depends on the size and layout of the building, the desire of the owner to improve life safety beyond minimum requirements, the year of construction and the code in force at the time of construction. - number of occupants - building height - level of disch...

RCW 46.61.035 (4) authorized emergency vehicles responding to a call to break laws that apply to other drivers but does not relieve the driver from the duty of driving with _______ regard for the safety of all persons. correct answers Due TRUE or FALSE: When a pump is supplying multiple lines, any sudden change in flow in one line ca cause a drastic and dangerous change in another. To combat this, automatic pressure regulators are needed to ensure the safety of all personnel T correct ans...