Nicet level 1 test - Study guides, Class notes & Summaries

NICET Level 1 Fire Alarm Inspection & Testing Questions and Answers Graded A+ Verification of performance of inspection and testing programs shall do which of the following to Verify that the installed system meets the operation requirements of the version of code when the system was installed, verify the correct operation of the system. Which of the following shall be done when conducting tests in lead-acid type batteries Annually conduct a discharge test with the charger disconnected...

NICET Fire Alarm Systems Level 1 Exam Questions And Revised Correct Answers If a combination audible/visible appliances are installed, the location of the installed appliance shall be determined by the requirements of - ANSWER : the visible appliance What is the maximum number of 12-gaugeTHHN conductors that can be installed in 1-inch EMT - ANSWER : 26 Do you resistors are connected in parallel. R1 = 300 Ohms, R2 = 300 Ohms. What is the equivalent resistance? - ANSWER : 150 Ohms...

Nicet level 1 Review Practice Exam Questions & Answers. When testing a water level supervisory switch serving a pressure tank a signal shall indicate if the water level _____________from the required level (NFPA 72, Table 14.4.3.2 17 (j) (4) - CORRECT ANSWER rises or falls over 3 inches If combination audible/visible appliances are installed the location of the installed appliance shall be determined by the requirements of _______. (Nfpa 72 18.4.8.1) - CORRECT ANSWER the visible ap...

TFM01 Exam Questions and Answers The fire marshal shall send notice to each examinee of the results of the examination no later than -Answer-30 days If the examination is conducted by a testing service the state marshal shall send notice of the results no later than -Answer-14 days If examination results will be delayed the state marshal shall send notice to the examinee no later than -Answer-90 days A renewal of a registration certificate or license is valid for a period of -Answer-2 yea...

NICET Level 1 inspection and Testing Questions and answers, rated A+, VERIFIED/ When using a pulse load tester on a sealed lead acid battery, the minimum acceptable capacity is... - 80% When a software change is made to a fire alarm system, what percentage of the initiating devices not affected by the change must be tested - 10% When testing elevator recall, the elevator should go to the alternate level when: - The lobby smoke detector on the recall level is activated Minimum requirem...

Nicet level 1 Study Guide questions and answers 100% pass When testing a water level supervisory switch serving a pressure tank a signal shall indicate if the water level _____________from the required level (NFPA 72, Table 14.4.3.2 17 (j) (4) - Answer-rises or falls over 3 inches If combination audible/visible appliances are installed the location of the installed appliance shall be determined by the requirements of _______. (Nfpa 72 18.4.8.1) - Answer-the visible appliance What is the ...

Nicet Level 1 water-based systems Practice Exam Questions and Answers 100% Pass What is a purpose of a control valve - Answer-Control Flow to water based fire protection system The gauge on the quick opening device shall indicate _____ as compared to the gauge on the system side of the dry pipe valve? - Answer-the same pressure What type of test shall be provided when a valve is returned to service to determine that the valve is open? - Answer-Valve status test What is a fire service mai...

Nicet Level 2: Concrete Exam Questions and Answers 2024 What is the testing frequency for concrete? - Answer-every 50 yards When should you take cylinder samples? - Answer-Every 100 yards What are the components on a batch ticket? - Answer-1. Ticket Number 2. Plant 3. Project Number 4. Mix ID 5. Time of Batch 6. Time arrival 7. Time Discharge 8. Time Completed 9. Mix proportions When should concrete samples should not be taken? - Answer-Before 10% and 90% of truck has been discharge...

NICET Level 1 ITM of Water-Based Systems (A+ Guaranteed) 2024 Update NICET Level 1 ITM of Water-Based Systems (A+ Guaranteed) 2024 Update Who is responsible for the inspection, testing, maintenance and impairment of a water based fire protection system? correct answers The Property owner or designated representative Who's responsibility is it to provide accessibility to components of a water based fire protection system? correct answers The property owner or designated representative ...

NICET Level 1 ITM of Water Based Systems Rated A+ What is a purpose of a control valve Control Flow to water based fire protection system The gauge on the quick opening device shall indicate _____ as compared to the gauge on the system side of the dry pipe valve? the same pressure What type of test shall be provided when a valve is returned to service to determine that the valve is open? Valve status test What is a fire service main? A pipe and its appurtenances on private prop...