Pumper test 2 - Study guides, Class notes & Summaries

HazMat Tech Course (Review Challenge). Questions and answers. 100% Accurate. Revision Guide. The "outcomes" of a HazMat incident are defined in terms of - -fatalities, injuries, property and environmental damage, and systems disruption During a leak incident, what resource would you use to locate nearby streams? - -Topographic map During a leak incident, what resource would you use to locate access routes and isolation control points for responders? - -Road map During a leak inci...

Fire protection engineers have established _____ PSI as a minimum required residual pressure when computing the available water for flow test results. - 20psi The most common gallonage rating for horizontal shaft pumps in use today are _____ - _____ GPM. - 500 - 1500 gpm A fire pump serving a standpipe system should be tested ______ - weekly A fire department pumper can effectively supply around ______ feet in a high rise building depending on hydrant pressure and other factors. - 450 feet...

Alabama Fire College Inspector 1/2 Already Graded A Fire protection engineers have established _____ PSI as a minimum required residual pressure when computing the available water for flow test results. 20psi The most common gallonage rating for horizontal shaft pumps in use today are _____ - _____ GPM. 500 - 1500 gpm A fire pump serving a standpipe system should be tested ______ weekly A fire department pumper can effectively supply around ______ feet in a high rise building depending on hy...

Driver Operator Pumper Correctly Answered Test 2024. Water - correct answer - most commonly used extinguishing agent - noncombustible - absorbs large amounts of heat Waters Boiling Point - correct answer 212° F Waters freezing point - correct answer 32°F Waters Expansion Rate - correct answer 1,700 to 1 at 500° F Law of Specific Heat - correct answer Measures the ability of any substance to absorb heat Measured in BTUs (British Thermal Units) 1 BTU = the amount of heat r...

Fire Inspector 2: Combined Fire protection engineers have established _____ PSI as a minimum required residual pressure when computing the available water for flow test results. - 20psi The most common gallonage rating for horizontal shaft pumps in use today are _____ - _____ GPM. - 500 - 1500 gpm A fire pump serving a standpipe system should be tested ______ - weekly A fire department pumper can effectively supply around ______ feet in a high rise building depending on hydrant pr...

Main purpose of a pumper correct answers Provide adequate water pressure and effective water streams Watts for Trucks correct answers 12,000 Watts What do antilock brakes do? correct answers Keep vehicle from skidding How long for apparatus to build pressure when it first starts? correct answers 60 seconds Majority of tenders carry how much water? correct answers gallons Long idling leads to these 2 things correct answers carbon buildup, wear on pistons What uses a pressure se...

while conducting a pump capacity test, if the net pump discharge pressure is correct but the nozzle flow is too high, the - the discharge gate must be closed further When using hose lines above ground, the usual pressure calculation is to add _____ psi for each story of the building below the fire floor. - 5 You should switch from pressure to volume mode when - more than half of the rated capacity of the pump will be required To calculate friction loss in 2 1/2" fire hose when the flow is...

Mobile Water Supply| Equipment and Apparatus Test| Review 2025| Complete 100% During an MWS apparatus inspection, the lowest acceptable fuel gauge reading is: A. full B. at least 2/3 full C. at least 1/2 full D. at least 3/4 full D. at least 3/4 full What type of valve is commonly used on mobile water supply apparatus for rapid water discharge? A. Gate valve B. Dump valve C. Ball valve D. Butterfly valve Which of the following apparatus is primarily used to transport large ...

Texas Commission on Fire Protection (TCFP) Driver/ Operator Test Questions and Answers 2024/2025. In 1720 what was the piece of equipment to replace the bucket brigade? Hand Pump Which NFPA standard required new fire apparatus to be designed so that all members riding on the fire apparatus would be provided a seated area inside an enclosed cab? NFPA 1500 What was the first gasoline powered fire apparatus to discharge water by using a large soda acid extinguisher? Chemical Wagon The real ...

FSVO State Test Latest Update Graded A+ Standard for Fire Apparatus Driver/Operator Professional Qualifications NFPA 1002 Standard for a Fire and Emergency Service Vehicle Operations Training Program NFPA 1451 What is designed to supplement the service brakes and that aid braking by using the engine's own systems to slow it down? Auxiliary brakes What are the sensors mounted on each wheel to control brake application in event of a sudden or emergent stop called? Antilock braki...