Maine Gas Exam Questions And Answers Latest Top Score.
2 views 0 purchase
Course
Maine Gas
Institution
Maine Gas
Maine Gas Exam Questions And Answers Latest Top Score.
Minimum vertical height for a Type B-W gas vent above the bottom of a wall furnace? - 12 Feet
Minimum thickness of a steel striker barrier for gas tubing protection? - 0.0508"
What is the maximum temp that a clay flue liner m...
Maine Gas Exam Questions And Answers
Latest Top Score.
Minimum vertical height for a Type B-W gas vent above the bottom of a wall furnace? -
12 Feet
Minimum thickness of a steel striker barrier for gas tubing protection? - 0.0508"
What is the maximum temp that a clay flue liner must be able to withstand without
cracking? - 1,800 degrees F
Combustion air obtained from indoors on the same story shall have a minimum of... -
Two openings
When gas is being supplied by a manifold located in a remote area, what is the
maximum distance the shutoff valve at the manifold can be located from the appliance?
- 50 feet
What reference standard covers the storage of liquid propane gas? - NFPA 58
A service station is being built with one boiler 28 feet away from the meter that uses
natural gas; all other equipment is electric. What size K or L semi-rigid copper tubing
should be installed to supply 205 cu. ft. of gas per hour with an inlet pressure less than
2 psi, pressure drop of 0.3 in. W.C. and a specific gravity of 0.60? - 1 "
Maximum distance a gas shut-off valve can be installed from the equipment it serves? -
6 feet
Maximum distance off the ceiling of the room shall an indoor combustion air opening be
installed? - 12"
, What is the minimum required clearance for an unlisted pool heater on all sides and
rear? - 12"
Flanges used for gas piping shall have gaskets made of an approved material designed
to withstand temperatures, pressure and chemical constituents of the gas. Which of the
following gasket materials is not acceptable? - Rubber
When corrosive or flammable fumes or gases are present near appliances, a safe
disposal method shall be provided. All of the following are considered flammable or
corrosive EXCEPT?! - Anhydrous Citric Acid
When a mechanical appliance is installed in an excavation deeper than 12", what shall
the excavation be lined with? - Copper pan
Which type of regulator is used in series with an another pressure regulator for the
purpose of automatically taking over in an emergency the control of the pressure down
stream in case the pressure tends to exceed a set maximum? - Monitoring
When more than 2 90° elbow's are required in a vent connector, the maximum capacity
of the connector shall be reduced for each additional 90° elbow by? - 10%
What is the minimum test pressure that can be used for testing newly installed gas
piping? - 3 psig
What is the minimum vertical distance to the bottom of a combustion air intake located
on the exterior of a building above adjacent finish ground level? - 12"
A residential boiler or furnace with a listed gas conversion burner and draft hood with a
type B gas vent shall have a minimum clearance from combustible materials of? - 6"
What is the maximum btu/hr input for an unlisted decorative appliance installed in a
vented fireplace with an 18 foot tall chimney and permanent free opening area of 29
in.²? - 50,400 BTU
All of the following piping materials are approved to be used for gas piping except... -
Cast Iron
What is the minimum size dimension of outdoor combustion air openings? - 3"
What is the maximum operating pressure for a low pressure steam boiler? - 15 psi
What is the maximum distance between horizontal supports for half inch OD copper
tubing used for gas supply piping? - 4 feet
What type of valve shall be used at the point of connection when a gas system has
supplementary standby gas connected downstream of the meter? - Three-way valve
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller techgrades. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $11.49. You're not tied to anything after your purchase.
