100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
ASE B-5 Mechanical/Electrical Exam Questions and Answers $12.49   Add to cart

Exam (elaborations)

ASE B-5 Mechanical/Electrical Exam Questions and Answers

 2 views  0 purchase
  • Course
  • ASE
  • Institution
  • ASE

ASE B-5 Mechanical/Electrical Exam Questions and Answers A vehicle is brought in with a bent subframe. Technician A says to section the subframe. Technician B says the subframe should not be repaired and must be replaced. Who is right? A, B, Both, or Neither - Ans:-Technician B only The subfra...

[Show more]

Preview 4 out of 33  pages

  • October 23, 2024
  • 33
  • 2024/2025
  • Exam (elaborations)
  • Questions & answers
  • ASE
  • ASE
avatar-seller
GraceAmelia
©GRACEAMELIA 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED

FIRST PUBLISH OCTOBER 2024




ASE B-5 Mechanical/Electrical Exam
Questions and Answers

A vehicle is brought in with a bent subframe. Technician A says to section the subframe. Technician B

says the subframe should not be repaired and must be replaced. Who is right?




A, B, Both, or Neither - Ans:✔✔-Technician B only




The subframe should never be sectioned, and should rarely, if ever, be worked. It is typically a bolt-on

part that does not lend itself to traditional straightening methods. Vehicle manufacturers recommend

replacement.


The first step in bleeding brakes is to:




A. check the parking brake adjustment


B. check the master cylinder fluid level


Page 1/33

, ©GRACEAMELIA 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED

FIRST PUBLISH OCTOBER 2024




C. start the engine and pump the brakes


D. start the wheel farthest from the master cylinder - Ans:✔✔-B. check the master cylinder fluid level




The fluid level will have to be monitored as it is removed during the process, so always start with a full

reservoir. Bleeding the farthest wheel first is good practice, but not the first thing to do.


Technician A says that negative camber is the tilt of the tire toward the front of the vehicle. Technician B

says that negative camber means that the top of the tire is tipped in toward the centerline of the vehicle.

Who is right?




A, B, Both, or Neither - Ans:✔✔-Technician B only




Camber is the inward or outward tip of the tire, as seen from the front of the vehicle. When a wheel

sustains an impact from the side, the camber is frequently affected.


During A/C refrigerant recovery, 1 oz of oil has been recovered from the system. Which of these is the

correct procedure?




Page 2/33

, ©GRACEAMELIA 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED

FIRST PUBLISH OCTOBER 2024




A. return the oil to the system


B. replace the oil with new oil


C. ignore such a small amount of new oil


D. change all the oil in the system - Ans:✔✔-B. replace the oil with new oil




New oil should be used to restore the proper amount. Also replace additional amounts for any

components replaced.


A vehicle has positive caster on the right front wheel and zero caster on the front left wheel. Technician A

says this will cause the vehicle to pull left. Technician B says the vehicle will pull to the right. Who is

right?




A, B, Both, or Neither - Ans:✔✔-A. Technician A only




The vehicle will always pull to the side with the least amount of positive caster, or the greatest amount

of negative caster.


Caster on one side of a unibody vehicle is out of specification. The LEAST likely cause is:

Page 3/33

, ©GRACEAMELIA 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED

FIRST PUBLISH OCTOBER 2024




A. a misaligned crossmember


B. a bent idler arm


C. a damaged lower control arm


D. a damaged strut rod - Ans:✔✔-B. a bent idler arm




A bent idler arm is the least likely problem. All the other choices could cause a caster problem.


After repairing a vehicle, it is found that camber is out of spec on one side of the vehicle. Technician A

says that there might be suspension mounting locations out of spec. Technician B says that before

adjusting camber, SAI and included angle should be checked and compared side-to-side. Who is right?




A, B, Both, or Neither - Ans:✔✔-Both Technician A and B.




A number of conditions can cause a camber reading to be off, such as damaged parts or a distorted

suspension mounting location. A visual examination of the parts is all that's needed in cases of severe




Page 4/33

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller GraceAmelia. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for $12.49. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

83637 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy study notes for 14 years now

Start selling
$12.49
  • (0)
  Add to cart