100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
NEC Master practice test Questions & Answers (RATED A+) $13.99   Add to cart

Exam (elaborations)

NEC Master practice test Questions & Answers (RATED A+)

 2 views  0 purchase
  • Course
  • NEC Master
  • Institution
  • NEC Master

1 in figure - ANSWERpower connection 7 in figure - ANSWERend seal A 30 degree kick has a hypotenuse of 10". Given that the cosecant of 30 degrees is 2, determine the side opposite or how far off the surface the end of the kick needs to be. - ANSWER5" A 30-microfarad capacitor is in paralle...

[Show more]

Preview 4 out of 68  pages

  • October 16, 2024
  • 68
  • 2024/2025
  • Exam (elaborations)
  • Questions & answers
  • nec master stuvia 2024
  • NEC Master
  • NEC Master
avatar-seller
ClassRep2
NEC Master practice test Questions & Answers (RATED
A+)

1 in figure - ANSWERpower connection



7 in figure - ANSWERend seal



A 30 degree kick has a hypotenuse of 10". Given that the cosecant of 30 degrees is 2, determine the
side opposite or how far off the surface the end of the kick needs to be. - ANSWER5"



A 30-microfarad capacitor is in parallel with a 15-microfarad capacitor. The total capacitance is ___ -
ANSWER45



A 5-ohm and a 20-ohm resistor are connected in parallel. What is the total resistance of these two
resistors? - ANSWER4 ohms



A buck-and-boost transformer has a primary current of 10A and the transformation ratio of 10:1.
What is the secondary current? - ANSWER100A



A cable hanger elbow is used to - ANSWERsuspend cables in long vertical runs



A carnival ride properly powered through a disconnect switch withing 6 feet of the operator can also
be opened from the operator's console using a - ANSWERshunt trip



A circuit diagram shows that the circuit divides into seperate branches and there are also series
loads. This is a ___ - ANSWERseries-parallel circuit



A circuit has a peak voltage of 275V. What is the average voltage value? - ANSWER175V



A circuit has a source voltage of 50V and a current of 10A. What is the power in watts? - ANSWER500



A clothing manufacturing plant would most likely be classified as ___. - ANSWERClass III

,A commercial kitchen with more than six pieces of kitchen equipment is subject to a demand factor
of ___ - ANSWER65%



A conductor with failed insulation contacts the metal edge of a grounded metal wireway. This is
known as a ____. - ANSWERground fault



A conduit run must pass over a pipe and then over a rectangular duct. This will require a total of
____ (bends). - ANSWERseven bends.



A conventional thermostat should not be thrown into the regular trash because it _____. -
ANSWERmay contain mercury



A correction factor must be applied if the ambient temperature is above ___ - ANSWER86 degrees
Fahrenheit



A current imbalance as low as 4 milliamps may be detected by a - ANSWERGFCI Sensor



A current-limiting circuit breaker performs in a manner similar to conventional thermomagnetic
circuit breakers at currents below a threshold of about - ANSWER1,000A



A cutaway view of a building or object is known as a - ANSWERsectional drawing



A delta-connected motor has ___ - ANSWER9 leads



A device that is used to step up generated voltage to make it suitable for commercial transmission is
called a - ANSWERpower transformer



A device that uses dissimilar metals to control electron flow is known as a - ANSWERthermocouple



A device that uses electromagnetic induction to transfer electrical energy from one circuit to another
is a ___ - ANSWERtransformer



A die used to - ANSWERcut the threads in conduit

,A digital device that sends fire alarm information over the public switched telephone network is
called a ____. - ANSWERDACT



A downed power line is most likely to result in a - ANSWERphase failure



A farm has 3 buildings with loads of 82A, 65A, and 15A. What is the total load? Assume that there
are no dwellings or motors. - ANSWER117 A



A feeder circuit with no motor load has a continuous load of 10A and a noncontinuous load of 10A.
The feeder overcurrent protective device should be sized at ____. - ANSWER22.5A



A feeder circuit with no motor load has a continuous load of 5A and a noncontinuous load of 5A. The
feeder overcurrent protective device should be sized at _____. - ANSWER11.25A



A feeder is used to connect - ANSWERthe main service panel and a subpanel



A fire alarm's secondary power can come from a battery or a ____. - ANSWERgenerator



A flange hanger is commonly used with a ____. - ANSWERsuspended fixture.



A freezestat is a - ANSWERnormally closed bimetal switch



A general-purpose NEMA enclosure is Type - ANSWER1



A GFCI sensor will trip when the - ANSWERcurrent in the neutral load is less than the current in the
hot load.



A good electrical connection should - ANSWERbe mechanically and electrically secure



A ground fault is best described as an unintentional - ANSWERelectrically conducting connection
between an ungrounded conductor of an electrical circuit and the normally non-current-carrying
conductors

, A ground test utilizing an auxiliary current electrode and an auxiliary potential electrode is known as
the - ANSWERthree-point test



A grounding electrode conductor - ANSWERmade of copper, aluminum, or copper-clad aluminum



A grounding wire may be which of the following? - ANSWERGreen



A knee in a leakage current-versus-voltage plot indicates a - ANSWERbreakdown current



A live-dead-live test is conducted in order to ___ - ANSWERverify that a circuit is de-energized



A medium-size motor has a frame number of 284T. The D dimension of this motor is ___ - ANSWER7"



A metric drawing scale of 1:100 typically depicts units in - ANSWERmillimeters



A mil is equal to - ANSWER.001 inch



A motor overload relay consists of a current-sensing unit and a mechanism activated by the sensing
unit that - ANSWERopens the motor circuit



A No. 1 isolated conductor must be identified using which of the following colors? - ANSWEROrange



A noncontinuous load of two 120V outlets for heavy-duty lamp holders would have a load of __ -
ANSWER1200VA



A pocket knife can be used to deburr - ANSWERPVC



A polyphase synchronous motor has three stator windings that are ___ - ANSWER120 degrees apart



A pulling line is usually made of - ANSWERnylon or other synthetic

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller ClassRep2. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for $13.99. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

81849 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy study notes for 14 years now

Start selling
$13.99
  • (0)
  Add to cart