100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
NATE AC SERVICE CERTIFICATION EXAM ,TEST &STUDY GUIDE 2024/2025 /COMPLETE ACTUAL EXAM QUESTIONS AND CORRECT ANSWERS (VERIFIED ANSWERS ) ALREADY GRADED A+. $26.99   Add to cart

Exam (elaborations)

NATE AC SERVICE CERTIFICATION EXAM ,TEST &STUDY GUIDE 2024/2025 /COMPLETE ACTUAL EXAM QUESTIONS AND CORRECT ANSWERS (VERIFIED ANSWERS ) ALREADY GRADED A+.

 2 views  0 purchase
  • Course
  • NATE AC SERVICE CERTIFICATION
  • Institution
  • NATE AC SERVICE CERTIFICATION

NATE AC SERVICE CERTIFICATION EXAM ,TEST &STUDY GUIDE 2024/2025 /COMPLETE ACTUAL EXAM QUESTIONS AND CORRECT ANSWERS (VERIFIED ANSWERS ) ALREADY GRADED A+. NATE AC SERVICE CERTIFICATION EXAM ,TEST &STUDY GUIDE 2024/2025 /COMPLETE ACTUAL EXAM QUESTIONS AND CORRECT ANSWERS (VERIFIED ANSWERS...

[Show more]

Preview 4 out of 60  pages

  • October 1, 2024
  • 60
  • 2024/2025
  • Exam (elaborations)
  • Questions & answers
  • NATE AC SERVICE CERTIFICATION
  • NATE AC SERVICE CERTIFICATION
avatar-seller
nyagajoseph539
NATE AC SERVICE CERTIFICATION EXAM ,TEST &STUDY GUIDE 2024/2025
/COMPLETE ACTUAL EXAM QUESTIONS AND CORRECT ANSWERS
(VERIFIED ANSWERS ) ALREADY GRADED A+.




A system is supplied from the factory with charge of 5 pounds 10
ounces for a 15 foot line set. The line set is 25 feet long. The
manufacturer's instruction sheet specifies 0.6 ounces of refrigeration
to be added for each added foot of refrigerant line set length. What is
the total refrigerant charge for the system?


A. 6 ounces
B. 5 pounds
C. 5 pounds 10 ounces
D. 6 pounds - ANSWER-D. 6 pounds


15ft - 25ft = 10ft x .6 = 6 ounces
5 pounds + 10 ounces + 6 ounces
5 pounds + 16 ounces = 6 pounds


The purpose of using flux when soldering is to:


A. anneal the surface.
B. give better heat flow.
C. reduce oxidation.
D. pre-seal the oxidation. - ANSWER-C. reduce oxidation.

,Outdoor condensing units that are installed in areas where flooding is
possible must:


A. be mounted above flood level.
B. utilize NEMA 1 enclosures.
C. be mounted under an overhanging eave.
D. use water resistant components. - ANSWER-A. be mounted above
flood level.


The component used to reduce sound transmission and prevent water
leaks on a rooftop air conditioner packaged unit installation is the:


A. curb gasket.
B. silicone caulk.
C. roof flashing.
D. roofing tar. - ANSWER-A. curb gasket.


Return air leakage in a hot attic will:


A. Increase capacity
B. Decrease capacity
C. Increase airflow
D. Decrease airflow - ANSWER-B. Decrease capacity


An air conditioner refrigerant circuit should be evacuated to a
minimum of:

,A. 0 microns.
B. 200 microns.
C. 500 microns.
D. 1200 microns. - ANSWER-C. 500 microns.


Which of the following substances could create an extremely
dangerous condition if used to check refrigeration system for leaks?


A. R-22
B. Nitrogen
C. Oxygen
D. Carbon Dioxide - ANSWER-D. Carbon Dioxide


The subcooling method for checking charge is generally used on air
conditioners with what type of metering?


A. Only externally equalized thermostatic expansion valves
B. Any thermostatic expansion valve
C. Piston type
D. Any fixed metering device - ANSWER-B. Any thermostatic
expansion valve


Supply ducts running through unconditioned space should be
insulated and have:


A. equal friction.

, B. excessive air velocity.
C. a vapor barrier.
D. a transition backing. - ANSWER-C. a vapor barrier.


An important consideration when installing a motorized economizer is
to check to be certain that:


A. the vanes are set for a maximum 10% outdoor air.
B. the vanes open on any call for cooling.
C. the vanes operate without binding.
D. the vanes are permanently set at 50%. - ANSWER-C. the vanes
operate without binding.


On a 3 ton unit installation, the measure airflow equals 1550 CFM.
What does this indicate?


A. Proper balancing
B. Low Airflow
C. Excess airflow
D. Improper balancing - ANSWER-C. Excess airflow(400cfm per ton, 3
ton=1200cfm)


Electronic type leak detectors typically have a push-button or knob
for setting a reference refrigerant level. This feature is useful for:


A. adjusting the detector after installing a new battery.
B. checking the factory calibration of the instrument.

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller nyagajoseph539. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for $26.99. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

81989 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy study notes for 14 years now

Start selling
$26.99
  • (0)
  Add to cart