A common practice to reduce boom torque is - ANSWER-Reeve the lines symmetrically
A crane component made by crane company can be used on any other crane made by
the company - ANSWER-False
A crane is set up with three of us for outriggers fully extended and the fourth retracted
unless the manufacturer states otherwise the capacity of the crane in this configuration
will be found in the - ANSWER-On Rubber chart
A crane must stay at least from energize powerlines under 50 Kv - ANSWER-10 feet
A crane operator must respond to a stop signal from - ANSWER-Eveyone
A crane performing personal lifts must not exceed of its rated capacity - ANSWER-50%
A crane sitting 3° off level can increase the boom stress by 50% - ANSWER-True
A cranes quadrants of operation is - ANSWER-Different depending on the
manufacturers load chart
A Jibbs offset is the Jibbs angle to the - ANSWER-Boom
A load applied at an angle to the vertical plane of the boom is referred to as - ANSWER-
Side load///// when you pick some thing not being directly over the Center of the load
A luffing jib on a conventional or hydraulic crane will - ANSWER-Boom up or down
independently of the main boom
A periodic inspection is made - ANSWER-Monthly to annually
A rough terrain crane is commonly referred to as - ANSWER-Cherry picker
A shift inspection must be completed - ANSWER-Before the end of shift
A standard hand signal chart must be posted conspicuously at the job site the ideal spot
for the chart is - ANSWER-On the crane
A sudden change in the speed of the left and attachments will produce a - ANSWER-
Shock load
,A sudden start or stop while operating a crane produces - ANSWER-A dynamic load
A sudden start or stop while operating a crane produces a - ANSWER-Dynamic load
A truck crane is operating with his outriggers fully extended and set does not have a fifth
front Outrigger the operator should - ANSWER-Referred to the manufactures working
area diagram
A truck crane is rated at what percentage of its load capacity - ANSWER-85%
According to be 30.5 mobile crane standard it's OK for an operator to leave the cab of a
crane with the engine running so long as - ANSWER-The operator keeps the crane in
view and restricts access to the area around the crane
AcCording to Inzi personal platform lift should not be made with wind an excess of -
ANSWER-20 mph
According to OSHA all cranes equipped with a luffing jib must have - ANSWER-Check
valve
After the crane has been checked out and before lift operations begin the crew should -
ANSWER-Have a pre-lift meeting
All bridals and rigging used for personal hoisting cannot be used and for any other
hoisting activities - ANSWER-True
All cranes equipped with a torque converter must have a - ANSWER-Clutch reachable
from the operators station
All hazards and potential problems should be discovered - ANSWER-Pre-operational
work site inspection
All load test shall not exceed what of the manufacturers rated capacity - ANSWER-
110%
An abrupt stop of a rapid swing on a long boom crane will produce what major affect -
ANSWER-Possible overturning the crane or collapsing the boom
And a range diagram boom length of an angle can be used to determine - ANSWER-
Load radius
And Outrigger float should be approximately how much larger than Outrigger pad -
ANSWER-3x
, Any gate or means of access/egress in a personal basket must not - ANSWER-Swing
outward
As the layers of rope on a drum increase the allowable line Pull wil - ANSWER-
Decrease
Backward stability of a crane is tested with - ANSWER-Basic boom at maximum angle
with no load
Backward stability on a mobile crane can become an issue when the crane is working -
ANSWER-Over the side at a minimum radius
Basket hitch is rated of a vertical hitch - ANSWER-200%
Before arriving at the job site with a crane and sure the cranes blank is adequate -
ANSWER-Set up location
Before leaving his crane unattended the operator must - ANSWER-Land the load set all
dogs and pawls and shut the engine
Before lifting a rated load the operator shall - ANSWER-Left the load a few inches off
the ground and apply the brake
Before performing a lift with a personal hoist the following must be done - ANSWER-
Trial pick
Proof lift
Pre-lift meeting
Blocking cribbing may be placed under the Outrigger beams - ANSWER-Never they go
under the pads
Blocking may be placed under the tips of the tracks on a crawler crane to - ANSWER-
Increased ability over the front or rear
Blocking under floats shall be - ANSWER-Sufficient to support the crane and the load
Boom angle is best described as - ANSWER-The angle between the loaded boom and
the horizontal
Boom connecting pins should be installed - ANSWER-From the inside out
Boom extensions and Jibbs are used - ANSWER-To increase height
Boom hoist sheaves shall have a minimum pitch diameter of - ANSWER-15 times rope
diameter
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller CLOUND. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $10.49. You're not tied to anything after your purchase.