100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
BPI MFBA (Fall ) Graded A+ $11.49   Add to cart

Exam (elaborations)

BPI MFBA (Fall ) Graded A+

 8 views  0 purchase
  • Course
  • BPI - Broadband Installation Professional
  • Institution
  • BPI - Broadband Installation Professional

BPI MFBA (Fall ) Graded A+

Preview 3 out of 22  pages

  • September 21, 2024
  • 22
  • 2024/2025
  • Exam (elaborations)
  • Questions & answers
  • BPI - Broadband Installation Professional
  • BPI - Broadband Installation Professional
avatar-seller
CLOUND
BPI MFBA (Fall 2023-2025) Graded A+
1.- A service call should be recommended when CO reaches 26 ppm inside the exhaust
vent of an oven: - ANSWER-False
(Service Call)

10.- Effervescence and brick work on the front of a building can come from any of these
causes except: - ANSWER-Condensation from a bathroom collecting on the vapor
diffusion retarder

10j.- You receive a complain that the exterior wall inside of a bathroom is always wet
after the tenant takes a shower. What is the cause? - ANSWER-The cold air from
outside is making the warm air from inside condensate on the wall.

11.- Which offers the highest thermal transmittance - ANSWER-High U - value

11k.- Which has the greater heat content: 5 gallons of #6 oil or 4 therms of natural gas?
- ANSWER-#6 oil

12.- Which has the greater potential heat - 3 gallons of #6 oil or 4 therm of natural gas?
(assume #6 oil is 150,000 BTUs per gallon) - ANSWER-#6 oil: 3 gallons x 150,000 =
450,000

Natural gas: 4 therms x 100,000 =400,000

#6 oil greater potential heat

12l.- Which offers the best THERMAL RESISTANCE? - ANSWER-High R-value

13.- Energy loss can be reduce on a line of exhaust vents by using: - ANSWER-
Constant Air Regulators (CARs)

13m.- The purpose of a CAR is to: - ANSWER-- Maintain constant airflow across
variations in pressure
- Maintain flows in the exhaust system that can vary with temperatures
- Mitigate Stack Effect

14.- Stack effect is common in high rise building. It can compromise Fire Safety and
IAQ. Which of these strategies is NOT a good way to address stack effect: - ANSWER-
Sealing Vents

14n.- Stack effect is common in high rise buildings. It can compromise fire safety and
IAQ.
Which of these strategies is not a good way to address Stack Effect? - ANSWER-
Sealing vents.

,15.- An HRV is more efficient than an ERV: - ANSWER-False

15o.- Sealing it tight and ventilating right means mechanical ventilation and pollution
source control are important to maintain AIQ. An ERV can help achieve these objectives
but not by: - ANSWER-Recovering air pressure

16.- Ice dams on a roof can create the following problems for a building. EXCEPT for: -
ANSWER-Poor Ventilation

16p.- An HRV or an ERV can be used in central ventilation systems but not in individual
apartments. - ANSWER-True

17.- Ice Dams form in the winter when temperatures go below freezing. Which of the
following is NOT GOOD strategy to prevent ice damming: - ANSWER-Sealing the roof
below the shingles

17q.- Ice Dams on a roof can create the following problems for a building, except for: -
ANSWER-Roof expansion

18.- In multifamily buildings, a cause of poor efficiency and IEQ in the central ventilation
system does NOT include: - ANSWER-Stack Effect

18r.- Ice Dams form in the winter when temperatures go below freezing. Which of the
following is no a good strategy to prevent ice damming? - ANSWER-Heating the roof

19.- An ERV in a Multifamily building saves energy by: - ANSWER-- Recovering
Sensible Heat
- Recovering Latent Heat
- Recovering Moisture

19s.- In multifamily buildings, when a central ventilation system is performing poorly it
can result in these problems, except: - ANSWER-Stack Effect

1a.- A vapor diffusion retarder protects insulation by: - ANSWER-Keeping away bulk
moisture from outside the building

2.- If a building requires 180,000 BTUs, how many therms are required if a boiler is 80%
efficient gas boiler when the temperature outside is 32F? - ANSWER-Units of fuel =
180,,000 x 80%
= 180,,000
= 2.25 therms

20.- MERV stands for Multiple Energy Recovery Ventilation: - ANSWER-False

20t.- The most efficient ventilation system has a MERV of 15 - ANSWER-True

, 21.- Moisture in a wall can lead to mold and deterioration. Strategies to prevent
moisture includes these steps except: - ANSWER-Installing a vapor diffusion barrier
behind the exterior cladding

21u.- Moisture in a building could increase relative humidity, pollen and bacteria. Critical
strategies to preventing moisture include these steps except: - ANSWER-Keeping bulk
moisture off the exterior cladding.

22.- When air pressures varies greatly in apartments, hallways, stairwells it can cause
which of these problems in a building: - ANSWER-- Odor migration
- Increase contaminants moving throughout a building.
- Health & safety issues

22v.- When air pressure varies greatly in apartments, hallways, stairways it can lead to?
- ANSWER-- Increase heat loads
- Increase contaminants moving into the building
- Increase energy use

23.- Ventilation airflow systems can be set at minimum rates as an energy efficiency
strategy. However, the airflow must meet which of the following standards: - ANSWER-
Design flow and applicable codes

BPI Standard 3.10

23w.- Ventilation air flow systems must meet the following standards: - ANSWER--
Local codes
- Design codes
BPI STANDARD 3.11

24.- When completing Utility Usage Analysis, it is important to collect data for all energy
and water use in the building for a least 10 months - ANSWER-False

BPI Standards 2.3 & 2.8

24x.-When evaluating utility usage analysis, consumption that is lower than predicted
should be evaluated due to equipment downtime, vacancy and other factors. If the utility
rate structure seems incorrect, what should the analyst recommend? - ANSWER-
Recommend an utility rate analysis by a qualify contractor.

25.- T12 light fixtures are being phased out by federal law. A building has 20 T12
fixtures in the basement area. Each fixture has 2 bulbs that are labeled D96T12 and a
ballast that uses 8 watts the auditor proposes replacing them with led light fixtures that
use 18 watts per bulb, what would be the annual energy cost saving (assume 24 hr/day
and $0.20 / kwh)? - ANSWER-T12: 40Bulb x 96w + 20bal x 8w / 1000
3840 + 160/1000 = 4kw

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller CLOUND. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for $11.49. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

67163 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy study notes for 14 years now

Start selling
$11.49
  • (0)
  Add to cart