100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
Previously searched by you
ATTSA TRAFFIC SUPERVISOR CERTIFICATION EXAM 2024 | 2 ACCURATE RECENTLY TESTING VERSIONS WITH A STUDY GUIDE | ACCUARATE AND EXPERT VERIFIED FOR GUARANTEED PASS$19.99
Add to cart
ATTSA TRAFFIC SUPERVISOR CERTIFICATION EXAM 2024 | 2 ACCURATE RECENTLY TESTING VERSIONS WITH A STUDY GUIDE | ACCUARATE AND EXPERT VERIFIED FOR GUARANTEED PASS
4 views 0 purchase
Course
ATTSA TRAFFIC SUPERVISOR CERTIFICATION
Institution
ATTSA TRAFFIC SUPERVISOR CERTIFICATION
ATTSA TRAFFIC SUPERVISOR
CERTIFICATION EXAM 2024 | 2 ACCURATE
RECENTLY TESTING VERSIONS WITH A
STUDY GUIDE | ACCUARATE AND EXPERT
VERIFIED FOR GUARANTEED PASSATTSA TRAFFIC SUPERVISOR
CERTIFICATION EXAM 2024 | 2 ACCURATE
RECENTLY TESTING VERSIONS WITH A
STUDY GUIDE | ACCUARATE AND EXPE...
ATTSA TRAFFIC SUPERVISOR
CERTIFICATION EXAM 2024 | 2 ACCURATE
RECENTLY TESTING VERSIONS WITH A
STUDY GUIDE | ACCUARATE AND EXPERT
VERIFIED FOR GUARANTEED PASS
When cones are substituted for drums for nighttime closers, what is the
minimum cone height requirement?
A. 18"
B. 28"
C. 36"
D. 42" - ANSWER>>42"
When cones are substituted for drums at nighttime closer, what is the maximum
cone spacing?
A. 20'
B. 30'
C. 40'
D. 50' - ANSWER>>40'
What type of flashing warning lights are required when there is a nighttime lane
closer?
A. ROAD WORK AHEAD
B. LANE CLOSED AHEAD
C. A & B
D. NONE OF THE ABOVE - ANSWER>>ROAD WORK AHEAD
&
LANE CLOSED AHEAD
If there is a lane closure of greater than three days, what is required?
,A. Work zone dotted lines, 4' in length separated by 10' gaps, shall be provided
to identify the merge.
B. The appropriate color work zone edge lines shall be applied along the taper
and tangent sections.
C. All the above
D. None of the above - ANSWER>>The appropriate color work zone edge lines
shall be applied along the taper and tangent sections
Is a shadow vehicle used in all traffic zones?
A. True
B. False - ANSWER>>False
The shadow vehicle is occupied whenever workers are in the work area.
A. True
B. False - ANSWER>>False
What class one light is the shadow vehicle equipped with?
A. Flashing Yellow Light
B. Oscillating Yellow Light
C. Yellow Strobe Light
D. All of the above - ANSWER>>All of the above
When may cones be substituted for drums?
A. Daytime traffic control minimum height 18"
B. Daytime traffic control minimum height 28"
C. Daytime traffic control minimum height 36"
D. Daytime traffic control minimum height 42" - ANSWER>>Daytime traffic
control minimum height 28"
When may cones be substituted for drums?
A. Daytime traffic control minimum height 18"
B. Daytime traffic control minimum height 28"
C. Daytime traffic control minimum height 36"
,D. Daytime traffic control minimum height 42" - ANSWER>>Daytime traffic
control minimum height 28"
.
Work zone pavement marking that conflict with final traffic lanes shall be
temporary paint.
A. True
B. False - ANSWER>>False
What are the extra advance warning signs?
A. Lane Close Ahead
B. Watch for Stopped Traffic
C. Road Work Ahead
D. All the above - ANSWER>>Lane Change Ahead
&
Watch for Stopped Traffic
&
Road Work Ahead
Is the advisory speed plaque used in all traffic zones?
A. True
B. False - ANSWER>>False
When the approach speed limit is 40 mph or less, 36" warning signs may be
used.
A. True
B. False - ANSWER>>True
Road Work Ahead signs shall be provided on entrance ramps or roadways
entering the work limits.
A. True
, B. False - ANSWER>>True
End Road Work signs are only required for lane closures of more than ______ day.
A. 1
B. 2
C. 3
D 4 - ANSWER>>1
Sign spacing should be adjusted to avoid conflict with existing signs, minimum
spacing to existing signs shall be 200' for speeds of 45 mph or less and a
minimum of 400' for speeds 50 mph or greater.
A. True
B. False - ANSWER>>True
The minimum acceptable length for the merge taper shall be determined by
_________ the width of the offset by the merge taper rate.
A. Subtracting
B. Adding
C. Divide
D. Multiplying - ANSWER>>Multiplying
The tangent (recovery area) section between the two merge tapers should be 2
times longer of the two merge tapers.
A. True
B. False - ANSWER>>True
What is a fundamental principle of temporary traffic control?
A. To inconvenience motorists as much as possible so they will find another
route.
B. To guide and direct motorists through or around the work area as efficiently as
possible. C. To make traffic move as slow as possible.
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller DOCJAMES. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $19.99. You're not tied to anything after your purchase.
