100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
NCCCO PT EXAM QUESTIONS AND ANSWERS $15.49   Add to cart

Exam (elaborations)

NCCCO PT EXAM QUESTIONS AND ANSWERS

 7 views  0 purchase
  • Course
  • NCCCO
  • Institution
  • NCCCO

NCCCO PT EXAM QUESTIONS AND ANSWERS

Preview 2 out of 11  pages

  • September 7, 2024
  • 11
  • 2024/2025
  • Exam (elaborations)
  • Questions & answers
  • NCCCO
  • NCCCO
avatar-seller
biggdreamer
NCCCO PT EXAM QUESTIONS AND
ANSWERS
Which unsafe condition could result when a wedge socket is attached directly to a load
hook, using 6x19 IWRC?
(A) Spinning of the load (B) Decreased line pull (C) Decreased safe working load (D)
Structural failure - Answer-(A) Spinning of the load

Which if the following will indicate intemal damage or ultimately core failure in rotation-
resistant rope?
(A) Strand bird caging (B) Diameter reduction (C) Excessive lubrication (D) Kinking -
Answer-(B) Diameter reduction

When a jib is erected from the stowed position and not used, how will its effective
weight change?
(A) It decreases (B) It increases (C) It will tip the crane (D) It stays the same - Answer-
(B) It increases

When operating a telescopic boom crane equipped with an anti two-block prevention
device, which hydraulic functions are disabled when the device is activated? (A) Winch
down, boom up, and retract the boom. (B) Swing, Winch down, and raise the boom. (C)
Hoist, extend the boom, and lower the boom. (D) Outrigger controls, retract the boom,
and swing. - Answer-(C) Hoist, extend the boom, and lower the boom.

A load applied at an angle to the vertical plane of the boom describes: (A) Over loading
(B) Side loading (C) Static loading (D) Angle loading - Answer-(B) Side loading

Hand signals must be posted conspicuously: (A) In the vicinity of hoisting operations B.
In the drivers cab of the crane (C) In the office. (D) In the load chart - Answer-(A) In the
vicinity of hoisting operations

Which crane hand signal is illustrated? (A) Retract the boom (B) Raise the boom (C)
Extend the boom (D) Lower the boom - Answer-(C) Extend the boom the

Power lines would be a big concern when considering a crane's set up location, another
big concern could be? (A) Radio communication with signal person (B) Capacity of the
crane (C) Gang members, crack heads, & tweakers (D) Voids, tanks, loose fill, &
depressions - Answer-(D) Voids, tanks, loose fill, & depressions

When inspecting the boom on a telescopic boom crane which item should be
inspected? (A) Float pads (B) Wear pads (C) Counterweight (D) Load block sheaves -
Answer-(B) Wear pads Counterweight

(A)when it's reeved over the main boom tip (B) when it's reeved over the auxiliary boom
head (C) when it's on top of the boom (D) when it's reeved over the jib - Answer-C

, When a crane operator leaves the crane, the operator must first: (A) Disengage the
PTO (B) Tum the engine off (C) Land all suspended loads (D) Secure the area and lock
out the controls. - Answer-C

Cranes operating with long booms should be most concerned with winds coming from
the: (A) Rear of the boom (B) Side of the Boom (C) East (D) South. - Answer-(B)

According to OSHA 1926 Subpart CC which of the following is prohibited with wire rope
on a crane? (A) Splicing (B) Cutting (C) Severing (D) Lubricating - Answer-(A)

If a crane is not set-up level and the operator swings a load from the high side to low
side, the load radius will: (A) Increase (B) Decrease (C) Stay the same (D), Increase
two feet for every one-degree out of level - Answer-(A)

Side loading may be caused by: (A) Starting or stopping the swing too rapidly (B)
Increasing the load radius (C) Raising or lowering the boom too rapidly (D) Raising or
lowering the load too rapidly - Answer-A

40. According to OSHA 1926 Subpart CC, Who may perform a shift inspection on a
mobile crane. (A) A practical examiner (B) An A/D Director (C) A competent person (D)
A qualified person - Answer-C

According to OSHA 1926 Subpart CC what must be included in a monthly inspection?
(A) Yearly Inspection (B) A new hoist line (C) Outrigger report (D) Documented shift
inspection - Answer-D

According to OSHA 1926 Subpart CC, which of the following is included in a crane shift
inspection? (A) Waming decals (B) Ground conditions (C) Leaking exhaust (D)
Hydraulic valves - Answer-(B)

During crane set up when an operator extends the cranes outriggers, the operator
should: (A) check tire pressure. (B) make visual contact with the outriggers or post a
signal person. (C) sound the hom. (D) place all blocking on the ground. - Answer-B

Float pads must be at a 90 degree angle and latched to the jack when the crane is set
up for a lift and when: (A) disassembling (B) performing a pick and carry operation (C)
working on rubber (D) the outriggers are in use - Answer-D

Examples of a duty-cycle operation high speed steel erection, magnet operations,
clamshell operations and: the handling of personnel platforms. B) high volume concrete
placement. (C) multi drum operations. (D) pile driving. - Answer-B

When operating a crane or boom truck, and the built level indicator is inoperable, to
level the crane the level should be placed on the upperworks or the: (A) Turret (B)
Control station (C) Bed (D) Rotator bearing - Answer-' A

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller biggdreamer. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for $15.49. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

76799 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy study notes for 14 years now

Start selling
$15.49
  • (0)
  Add to cart