CISCO CCNA V7.0 EXAM 2024/2025
WITH 100% ACCURATE SOLUTIONS
Refer to the exhibit. What will router R1 do with a packet that has a
destination IPv6 address of 2001:db8:cafe:5::1? - Precise Answer
✔✔forward the packet out Serial0/0/0
Refer to the exhibit. Currently router R1 uses an EIGRP route learned
from Branch2 to reach the 10.10.0.0/16 network. Which floating static
route would create a backup route to the 10.10.0.0/16 network in the
event that the link between R1 and Branch2 goes down? - Precise
Answer ✔✔ip route 10.10.0.0 255.255.0.0 209.165.200.225 100
Refer to the exhibit. R1 was configured with the static route command ip
route 209.165.200.224 255.255.255.224 S0/0/0 and consequently users
on network 172.16.0.0/16 are unable to reach resources on the Internet.
How should this static route be changed to allow user traffic from the
LAN to reach the Internet? - Precise Answer ✔✔Change the destination
network and mask to 0.0.0.0 0.0.0.0
Which option shows a correctly configured IPv4 default static route? -
Precise Answer ✔✔ip route 0.0.0.0 0.0.0.0 S0/0/0
Refer to the exhibit. Which static route command can be entered on R1
to forward traffic to the LAN connected to R2? - Precise Answer
✔✔ipv6 route 2001:db8:12:10::/64 S0/0/1 fe80::2
,What is a method to launch a VLAN hopping attack? - Precise Answer
✔✔introducing a rogue switch and enabling trunking
A cybersecurity analyst is using the macof tool to evaluate
configurations of switches deployed in the backbone network of an
organization. Which type of LAN attack is the analyst targeting during
this evaluation? - Precise Answer ✔✔MAC address table overflow
Refer to the exhibit. A network administrator is configuring a router as a
DHCPv6 server. The administrator issues a show ipv6 dhcp pool
command to verify the configuration. Which statement explains the
reason that the number of active clients is 0? - Precise Answer ✔✔The
state is not maintained by the DHCPv6 server under stateless DHCPv6
operation
Refer to the exhibit. A network administrator configured routers R1 and
R2 as part of HSRP group 1. After the routers have been reloaded, a user
on Host1 complained of lack of connectivity to the Internet The network
administrator issued the show standby brief command on both routers to
verify the HSRP operations. In addition, the administrator observed the
ARP table on Host1. Which entry should be seen in the ARP table on
Host1 in order to gain connectivity to the Internet? - Precise Answer
✔✔the virtual IP address and the virtual MAC address for the HSRP
group 1
,Which statement is correct about how a Layer 2 switch determines how
to forward frames? - Precise Answer ✔✔Frame forwarding decisions
are based on MAC address and port mappings in the CAM table.
Which statement describes a result after multiple Cisco LAN switches
are interconnected? - Precise Answer ✔✔The broadcast domain expands
to all switches.
Layer 1 Problem - Precise Answer ✔✔down/down
Layer 2 Problem - Precise Answer ✔✔up/down
Match the step to each switch boot sequence description. (Not all
options are used.) - Precise Answer ✔✔1. execute POST
2. load the boot loader from ROM
3. CPU register initializations
4. flash file system initialization
5. load the IOS
6. transfer switch control to the IOS
Refer to the exhibit. How is a frame sent from PCA forwarded to PCC if
the MAC address table on switch SW1 is empty? - Precise Answer
✔✔SW1 floods the frame on all ports on SW1, excluding the port
through which the frame entered the switch.
, An administrator is trying to remove configurations from a switch. After
using the command erase startup-config and reloading the switch, the
administrator finds that VLANs 10 and 100 still exist on the switch.
Why were these VLANs not removed? - Precise Answer ✔✔Because
these VLANs are stored in a file that is called vlan.dat that is located in
flash memory, this file must be manually deleted.
Default VLAN - Precise Answer ✔✔all switch ports are assigned to this
vlan after initial bootup of the switch
Management VLAN - Precise Answer ✔✔an ip address and subnet
mask are assigned to this vlan, allowing the switch to be accessed by
HTTP, Telnet, SSH or SNMP
Data VLAN - Precise Answer ✔✔Configured to carry user-generated
traffic.
Refer to the exhibit. A network administrator has connected two
switches together using EtherChannel technology. If STP is running,
what will be the end result? - Precise Answer ✔✔STP will block one of
the redundant links.
What is a secure configuration option for remote access to a network
device? - Precise Answer ✔✔Configure SSH.
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller YANCHY. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $16.49. You're not tied to anything after your purchase.