Power Engineering 4th Class - A11 all questions and verified answers
4 views 0 purchase
Course
Power Engineering
Institution
Power Engineering
Power Engineering 4th Class - A11 all questions and verified answers
The purpose of a superheater is to:
a. Control the pressure of the steam
b. Increase the temperature of the steam
c. Increase the steam output
d. Produce high pressure steam - ANS b
A membrane water wall:
a. Has wa...
Power Engineering 4th Class - A11 all
questions and verified answers
The purpose of a superheater is to:
a. Control the pressure of the steam
b. Increase the temperature of the steam
c. Increase the steam output
A
d. Produce high pressure steam - ANS b
VI
A membrane water wall:
a. Has waterproof membranes lining the tubes
TU
b. Has firebrick in front of the tubes
c. Has metal plates welded between the tubes
d. Consists of a metal sheeting in front of the tubes - ANS c
IS
A cyclone separator in a boiler steam drum:
a. Discharges water into the scrubbers
OM
b. Is located at the superheater outlet
c. Causes impurities to be thrown from the boiler water
d. Removes moisture from steam, using centrifugal force - ANS d
A high-pressure steam boiler is one in which steam is generated at a pressure greater
NA
than:
a. 76.4 kPa
b. 51.2 kPa
JP
c. 101.3 kPa
d. 100 kPa - ANS d
In a bottom-supported boiler, the steam drum is usually:
a. Placed between the centre line of the unit
b. Supported by piers
c. Supported by the water tubes
d. Supported by an overhead girder arrangement - ANS c
,An advantage of a packaged, low-pressure tubular or watertube boiler is:
a. Safety due to the low potential energy of the water contained within them
b. Its lower initial cost
c. Its less critical water treatment requirement
d. Its ability to meet load changes due to its heat reserve - ANS a
An early shell-type boiler had ___________ as its heating surface:
A
a. Two passes along the shell or drum
b. The total shell side and one end plate or head
VI
c. The lower part of the shell and the rear plate or head
d. Only the lower part of the shell - ANS d
TU
The steam space of a boiler must be large enough to:
a. Accommodate all the steam riser tubes
b. allow the steam to rise from the surface of the water
IS
c. Reduce the cooling effect of water
d. Keep the steam pressure down - ANS b
OM
As per ASME section I and section IV, a steam boiler operating at a pressure of ______
or higher is considered a Power Boiler.
a. 15 psig / 103.1 kPa
b. 14.7 psig / 100 kPa
NA
c. 14.7 psig / 101.3 kPa
d. 15 psig / 100 kPa - ANS d
The furnace walls in a bent-tube watertube boiler are formed by water filled tubes,
called:
JP
a. Waterside walls
b. Fireside walls
c. Waterwalls
d. Furnace walls - ANS c
When an air heater is used in a boiler:
, a. The boiler usually has only a forced draft fan
b. A balanced draft system cannot be used
c. It increases the efficiency of the boiler
d. The induced draft fan supplies combustion air to the air heater - ANS c
An advantage of a vertical tubeless firetube boiler is that it requires:
a. Very little water treatment
b. Less fuel for combustion
c. No fuel handling equipment
A
d. Relatively small floor space - ANS d
VI
Class 1 water treatment, as per ASME section VI, is suitable for:
a. Watertube Heating Boilers
TU
b. Tubular heating boilers
c. Firetube Heating Boilers
d. Cast Iron boilers - ANS d
IS
A watertube boiler is a boiler in which:
a. Combustion gases pass through the tubes
OM
b. Water passes around the tubes
c. Air passes through the tubes
d. Water passes through the tubes - ANS d
Immersion boiler tube bundles:
NA
a. Have negligible electrical resistance
b. Withstand extremely high temperatures and pressures
c. Can be easily removed from the unit for maintenance purposes
d. Conduct current through the boiler water - ANS c
JP
One type of electrode boiler depends on the electrodes being submerged in water in
order to generate steam. What safety device is not required on this type of electric
boiler?
a. Low water cut-off
b. Blow-off valve
c. Gauge glass
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller JPNAOMISTUVIA. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $10.99. You're not tied to anything after your purchase.
