Power engineering 5th class Questions and Answers: Tie Rods
4 views 0 purchase
Course
Power engineering
Institution
Power Engineering
Power engineering 5th class Questions and Answers: Tie Rods
Cast-iron sectional boilers have flue gas passages which - ANS Increase heat transfer
Steel plate heating boilers have thin steel installed in the - ANS Firetubes to give the gases a swirling motion
The vertical firetube boile...
Power engineering 5th class Questions
and Answers: Tie Rods
Cast-iron sectional boilers have flue gas passages which - ANS Increase heat transfer
Steel plate heating boilers have thin steel installed in the - ANS Firetubes to give the
gases a swirling motion
A
The vertical firetube boiler has a cylindrical shell with tubes connected between the -
ANS Upper and lower tube sheets
VI
Vertical firetube boilers have an advantage when___________ is limited. - ANS Floor
space
TU
The "A" type boiler is constructed with _________ drums. - ANS three
In general construction the Firebox boiler is not unlike the____________ boiler. - ANS
IS
locomotive
A modular cast-iron heating boiler - ANS Consists of a number of horizontal sectional
OM
cast-iron boilers
The HRT boiler is classified as a _______ pass boiler. - ANS two
The boilers or modules in a multiple heating boiler plant are: - ANS Most typically
NA
connected in parallel between the supply and return header
The switch in the operating control of a steam boiler is closed by: - ANS Falling steam
pressure
JP
A thermocouple consists of two dissimilar wires welded together at one end to form a: -
ANS Hot junction
A heating boiler must have a permanently attached marker indicating: - ANS Lowest
permissible water level
What is the name given to the component that coordinates and sequences the boiler
operation? - ANS Programming controller
,On a hot water boiler, the highest value on the graduated scale of the pressure gauge
shall not be less than ______ times the pressure at which the pressure relief valve is
set. - ANS 1.5
The programmed startup sequence of oil-fired boilers with no pilot light is as follows: -
ANS 1. The operating control closes a switch
2. The load relay energizes the ignition transformer, fuel oil shut-off valve, and motor
driving the air fan and fuel pump
3. The spark from the ignition transformer ignites the main burner
A
4. The flame detector senses the flame and causes the flame relay to close5. The
ignition transformer is then de-energized
VI
The boiler vent valve is used for the purpose of allowing: - ANS Air to escape while
filling
TU
If for any reason, the burner should go out during normal operation, or the fuel should
fail to ignite during startup: - ANS The fuel to the burner must be shut off immediately
IS
The discharge piping from the relief valve should be piped to a safe point for disposal
and can be: - ANS Terminated above a floor drain
OM
The time taken for the automatic pilot valve to close in the event of a loss of flame
detection is about ______ seconds - ANS 10
The boiler firebox, gas passages and chimney should be thoroughly cleaned by wire
brushing and: - ANS Vacuuming
NA
Leakage of a few drops a minute leakage from the packing gland of circulating pumps is
desirable to prevent drying out of packing and: - ANS Scoring of the shaft
Boiler explosions may be listed under two general classifications: - ANS Furnace
JP
explosions and Pressure explosions
If the water level in a steam boiler is found to be below the gauge glass, the boiler
should be: - ANS Shut down immediately
When inspecting the fireside of the boiler the surfaces are examined for bulges or
blisters which would indicate: - ANS Overheating
, Which of the following is done to prevent excessive stresses of boiler metal due to
uneven expansion? - ANS Warm the boiler up as slowly as possible
The dye penetrant, entrapped in a crack, is brought to the surface by the action of the: -
ANS Developer
The boiler certificate of inspection: - ANS Should be conspicuously placed adjacent to
the boiler or retained and safeguarded in a manner approved by the inspector
With reference to Power Engineering the letters "SIAP" mean: - ANS Sense, Interpret,
A
Analyze, Perform
VI
Hydrostatic testing of a boiler requires that the pressure be raised to ___________ the
Maximum Allowable Working Pressure stamped on the boiler. - ANS 1.5 times
TU
An intermittent pilot: - ANS Is automatically ignited at the start of each burner
operation and continues to burn throughout the main burner period
Upon activation the two-way pilot valve in the diaphragm gas valve switches so that the:
IS
- ANS Supply port closes and the bleed port opens
Air is composed of mostly: - ANS Nitrogen
OM
The oil is supplied to the burner mechanical atomizing nozzle under high pressure of
about: - ANS 700 kPa (100 psi)
The pump type motorized gas valve uses a hydraulic oil pump to: - ANS Open the gas
NA
valve slowly
Too much excess air will cause: - ANS Large amounts of heat out through the stack
Viscosity is a measure of the ____________________ of the oil. - ANS Internal
JP
resistance to flow
An advantage of a refractory burner is: - ANS The short luminous flame spreads over
a large cross-section of the furnace resulting in high radiant heat transfer
The average heating value of coal (bituminous) is: - ANS 25 600 kJ/kg (11,000 Btu/lb)
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller JPNAOMISTUVIA. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $11.99. You're not tied to anything after your purchase.
