Electrical NCCER test Questions And Answers All Correct
14 views 0 purchase
Course
NCCER Electrical
Institution
NCCER Electrical
Electrical NCCER test Questions And Answers All Correct
In a guardrail system, the guardrails can be made of any of the following EXCEPT: - ANS rope banding
If the potential across the circuit is 48 volts and the current is 5 amps the resistance of the circuit is: - ANS 9.6 ohms
A UL li...
In a guardrail system, the guardrails can be made of any of the following EXCEPT: - ANS rope banding
If the potential across the circuit is 48 volts and the current is 5 amps the resistance of the circuit is: -
ANS 9.6 ohms
K
A UL listed rod type grounding electrode must have a minimum length of: - ANS 8'
What is the MINIMUM number of overload sensing units required for all three phase motors? - ANS 3
C
In a circuit of pure capacitance, the current leads the voltage by an angle of: - ANS 90-degrees
LO
The standard unit for a measuring the cross-sectional area of a wire is the: - ANS circular mil
The drawing scale is MOST likely to be found in which of the following drawing locations? - ANS the
drawing little block
YC
The length of a bare copper conductor in a ground ring MUST be buried no less than 2.5' below grade and
with a length of at least: - ANS 20 ft.
When installing heating cables for anti-icing systems, cable patters should be in a: - ANS Serpentine
An auxiliary holding contact (seal-in) on a NEMA starter is indicated by the terminal marking: - ANS
D
A1 & A2
The neutral bus in a sub panel: - ANS is bonded
U
The PEAK voltage in a nominal 120/208 VAC system is: - ANS 208V.
ST
THWN conductors have an outer jacket made of: - ANS nylon
What is shown on a sectional drawing? - ANS Cutaway view of a building
Who is allowed to remove another electrician's tag or lock from any valve, switch, or piece of equipment
without proper authorization? - ANS no one.
The MAIN purpose of a revision block on an electrical drawing is to: - ANS note any changes to the
original drawings
, Which of the following is the classified location where combustible vapors are always present? - ANS
class I Div I
With a row of 3-4" conduits and second row of 3-2" and 2-1" conduits for an angle pull box what is the
MINIMUM distance between the opposite walls of the pull box? - ANS 32"
Exposed field-routed electrical conduit SHOULD be installed so that it: - ANS is plumb and level
When wiring control push button control circuit, the auxiliary holding contact (seal-in) is wired with the
start button in: - ANS parallel
K
Ferrous metal raceways, boxes, fittings, and supports must be protected against: - ANS corrosion
C
Which of the following factors is used to control the speed of an induction motor? - ANS Frequency
Electrical hand tools that use a regular 120-volt system MUST be 3-wire grounded UNLESS the: - ANS
LO
tool is double-insulated and is approved by an independent testing facility.
A conductor with 220 mils of insulation would have insulation thickness of: - ANS 0.22"
What is the purpose of sealing cable ends that are in storage? - ANS to keep moisture from entering it
YC
Which one of the fuses is a standard size according to the NEC? - ANS 3
A 1000 KVA three phase transformer has a secondary voltage of 208/120. What is the secondary full load
amperage? - ANS
D
A megohmmeter will be used to check a cable. The electrician MUST be sure that the circuit is - ANS
de-energized and locked, tagged out, and tested.
U
A protective device for limiting voltage spikes by discharging or bypassing surge current is called a: -
ANS surge limiter
ST
What is the resultant distance between center bends for a 10-inch offset at 15 degrees? - ANS 38.7 In.
What is the symbol for the SECONDARY side of a transformer? - ANS x
The most common transformer found on an industrial site is: - ANS Single phase step down
Applications for heat tracing systems with self regulating control include those requiring a narrow
operating range and: - ANS temperature sensitive fluids
With a row of 3-4" conduits and second row of 3-2" and 1-1" conduits on each side for a straight pull box
what is the MINIMUM distance between the opposite walls of the pull box? - ANS 32"
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller Studyclock. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $8.99. You're not tied to anything after your purchase.