5/1 NFPA70E Final nd Questions With 100%Verified Answers A+GRADED
5 views 0 purchase
Course
NFPA 70
Institution
NFPA 70
5/1 NFPA70E Final nd Questions With 100%Verified Answers A+GRADED
NFPA 70E, Standard for Electrical Safety in the Workplace, consists of ? chapters; 17 informative annexes; the Foreword to NFPA 70E; and Article 90, Introduction. Chapter 1 is divided into ? articles. - correct answer...3/5
The...
5/1 NFPA70E Final nd Questions With
100%Verified Answers A+GRADED
NFPA 70E, Standard for Electrical Safety in the Workplace, consists of ? chapters; 17
informative annexes; the Foreword to NFPA 70E; and Article 90, Introduction. Chapter 1
is divided into ? articles. - correct answer...✔✔3/5
The appointment of the NFPA 70E Committee was announced on January 7, ? , and
was formed to assist ? in preparing electrical safety standards that would serve its
requirements. - correct answer...✔✔1976/OSHA
The 1995 edition of NFPA 70E included the concepts of ? and the establishment of an
arc. The 2000 edition continued to focus on establishment of flash protection
boundaries, the use of personal protective equipment, and ? to assist the user in
applying appropriate protective clothing and personal protective equipment for common
tasks. - correct answer...✔✔Limits of Approach/Charts
The 2004 edition of NFPA 70E introduced the requirements of ? . The 2018 edition ? all
previous editions. - correct answer...✔✔The energized electrical work permit /
supersedes
NFPA 70E Chapter 1 applies generally to electrical safety in the workplace. Chapter 2
addresses safety-related ? requirements. Chapter 3 ? Chapter 1 with safety
requirements for special equipment. - correct answer...✔✔maintenance / supplements
or modifies
Explanatory material is included in the form of informational notes, which are not
enforceable as requirements. Brackets containing section references to another NFPA
document are for informational purposes only and are provided as a guide to indicate
the source of the extracted text. - correct answer...✔✔True
An arc flash hazard is defined in Article 100 as a source of possible injury or damage to
health associated with the release of energy caused by an electric arc. Informational
Note No. 1 indicates that the likelihood of occurrence of an arc flash incident increases
when energized electrical conductors or circuit parts are exposed or when they are
within equipment in a(n) ? condition, provided a person is interacting with the equipment
in such a manner that could cause an electric arc. An arc flash incident is not likely to
occur under normal operating conditions when enclosed energized equipment has been
properly installed and ? - correct answer...✔✔guarded or enclosed / maintained
Arc rating is defined in Article 100, in part, as the value attributed to materials that
describes their performance with exposure to an electrical arc discharge and is
expressed ? . Informational Note No. 1 states, in part, that arc-rated clothing or
equipment has been tested for exposure to an electric arc and that flame-resistant (FR)
AGRADESOLUTIONS
,clothing without an arc rating ? been tested for exposure to an electric arc - correct
answer...✔✔in cal/cm2 / has not
ATPV is defined in ASTM F1959/F1959M as the incident energy (cal/cm2) on a material
or a multilayer system of materials that results in a ? probability that sufficient heat
transfer through the tested specimen is predicted to cause the onset of a second degree
skin burn injury based on the Stoll curve. EBT is defined in ASTM F 1959-06 as the
incident energy (cal/cm2) on a material or a material system that results in a ?
probability of break open. - correct answer...✔✔50% / 50%
The Informational Note to the definition of arc flash boundary states that, according to
the Stoll skin burn injury model, the onset of a second degree burn on unprotected skin
is likely to occur at an exposure of ? for one second. - correct answer...✔✔1.2 cal/cm2
An approach limit at a distance from an exposed energized electrical conductor or
circuit part within which a shock hazard exists - correct answer...✔✔Limited Approach
Boundary
An approach limit at a distance from an exposed energized electrical conductor or
circuit part within which there is an increased likelihood of electric shock, due to
electrical arc-over combined with inadvertent movement - correct answer...✔✔
Restricted Approach Boundary
When an arc flash hazard exists, an approach limit from an arc source at which incident
energy equals 1.2 cal/cm2 (5 J/cm2) - correct answer...✔✔Arc-Flash Boundary
An electrical hazard is defined as a dangerous condition such that contact or ? can
result in electric shock, arc flash burn, thermal burn, or ? . - correct answer...✔✔
equipment failure / arc blast injury
Incident energy is defined as the amount of thermal energy impressed on a surface, a
certain distance from the source, generated during an electrical arc event. Incident
energy is typically expressed in ? - correct answer...✔✔calories per centimeter squared
(cal/cm2)
A qualified person is defined as one who has demonstrated skills and knowledge
related to the construction and ? of electrical equipment and installations, and has
received safety training to ? the hazards and reduce the associated risk. - correct
answer...✔✔operation / identify
An unqualified person is defined as a person who is not a qualified person - correct
answer...✔✔True
The requirements that address host and contract employer's responsibilities require a
number of things. Which of the following are among those requirements? - correct
AGRADESOLUTIONS
, answer...✔✔1. The contract employer must ensure that each employee follows the
work practices required by NFPA 70E in addition to any safety-related work rules of the
host employer.
IV. The host employer must inform the contract employer with the information about the
employer's installation that the contract employer needs to make the assessments
required by Chapter 1 of NFPA 70E
V. There must be a documented meeting between the host employer and the contract
employer where the host employer has knowledge of hazards covered by NFPA 70E
that are related to the contract employer's work.
The electrical safety training requirements in 110.2(A) state that employees are required
to be trained in a number of topics. Which of the following are among those employee
training topics? - correct answer...✔✔I. In safety-related work practices and procedural
requirements, as necessary, to provide protection from the electrical hazards associated
with their respective job or task assignments
III. To identify and understand the relationship between electrical hazards and possible
injury
IV. To understand the specific hazards associated with electrical energy
Determine which of the following are required to meet the NFPA 70E requirements
related to emergency response training. - correct answer...✔✔II. Employees exposed
to shock hazards and those responsible for the safe release of victims from contact with
exposed energized electrical conductors or circuit parts shall be trained in methods of
safe release.
III. Employees responsible for responding to medical emergencies shall be trained in
first aid and emergency procedures.
IV. Employers shall verify at least annually that employee emergency response training
is current.
V. The employer shall document that emergency response training has occurred.
The employer must document that each employee has received the training required by
110.2(A). This documentation of training must satisfy which of the following criteria? -
correct answer...✔✔I. It must be made when the employee demonstrates proficiency in
the work practices involved.
II. It must be maintained for the duration of the employee's employment.
III. It must contain the content of the training, each employee's name, and dates of
training
Identify which of the following statement(s) is/are true as they relate to unqualified
persons. - correct answer...✔✔I. An unqualified person is defined as a person who is
not a qualified person.
III. Unqualified persons must be familiar with any electrical safety-related practices
necessary for their safety.
IV. Unqualified persons must be trained in any electrical safety-related practices
necessary for their safety.
AGRADESOLUTIONS
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller agradesolutions. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $11.99. You're not tied to anything after your purchase.
