100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
Driver Operator Part II (questions 67-133) Questions and Answers $14.99   Add to cart

Exam (elaborations)

Driver Operator Part II (questions 67-133) Questions and Answers

 5 views  0 purchase
  • Course
  • FIRE APPARATUS DRIVER/OPERATOR - PUMPER
  • Institution
  • FIRE APPARATUS DRIVER/OPERATOR - PUMPER

Driver Operator Part II (questions 67-133)

Preview 2 out of 5  pages

  • August 26, 2024
  • 5
  • 2024/2025
  • Exam (elaborations)
  • Questions & answers
  • FIRE APPARATUS DRIVER/OPERATOR - PUMPER
  • FIRE APPARATUS DRIVER/OPERATOR - PUMPER
avatar-seller
julianah420
Driver Operator Part II (questions 67-
133)


_____ is the desired pump pressure when supplying two lines of 2-1/2" hose, one 200
feet long and one 300 feet long, each with a 250 gpm nozzle operating at 100 psi. -
answer137.5 psi

A COMMON reason for eductor failure is: - answerimproper cleaning and maintenance
of equipment

Steering wheel ply should usually be no more than approximately ____ degrees in
either direction. - answer10

When positioning a pumper to supply a fire department connection, the driver must
consider the: - answerpositioning requirements of other apparatus

When a apparatus driver is faced with a situation requiring evasive tactics, the driver
should attempt to pass the overtaken vehicle on: - answerthe left side

You have responded to an emergency on a limited-access highway. Your apparatus is
not being used, so you should - answeruse the apparatus as a barrier between the
traffic flow and the responders on scene.

In washing a newer apparatus, you should: - answerwash with automotive shampoo
and cold water.

When performing a capacity test, the desire net pump pressure should be ___ psi. -
answer150

The part of the total pressure not used to overcome friction or gravity while forcing water
through fire hose, pipe, fittings, and adapters is known as: - answerresidual pressure.

______ is the result of over-throttling. - answeradditional fuel consumption

Because of the size of an apparatus, as well as the clearance needed when backing,
the driver/operator should: - answerassign a firefighter to clear the way and warn the
driver/operator of any obstacle obscured by blind spots.

When relay pumping, the intake relief valve should be set at: - answer10 psi above the
static pressure

, While conducting a pump capacity test, if the net pump pressure is correct but the
nozzle flow (gpm) is too high, the: - answerdischarge gate must be closed further AND
throttle setting must be reduced.

A braking system that has a snow-and-mud switch is known as a(n): - answerantilock
braking system with automatic traction control

You encounter a school bus with flashing signal lights while responding to a call. You
must stop and proceed: - answeronly after a proper signal is given by the bus driver or
police officer.

A 5" diameter hose would be expected to flow approximately the same amount as: -
answerfour 2-1/2" hoses

______ is the nozzle reaction from a 1-1/4" tip at 50 psi nozzle pressure. - answer123
lbs

A ladder pipe with a 2-inch tip at 80 psi nozzle pressure will have approximately ____
pounds of nozzle reaction. - answer500

High-energy foam systems introduce - answercompressed air into the foam solution
prior to discharge into the hoseline

In a relay pumping operation, ____ should be positioned nearest the water source -
answerthe largest capacity pumper

One gallon of water weighs ____ pounds - answer8.33

The device that controls pressure surges by changing engine speed to compensate for
changes in flow is called a: - answerpressure governor

______ primer utilizes the venturi principle. - answerexhaust primer

Level II staging may be - answerused when a large number of emergency vehicles are
responding to the same incident

During an extended period of pumping, a gradual increase in engine temperature is
noted. The first step to reduce this condition would be: - answergradually open "engine
cooler"

At a wildland fire, in order to reduce the risk to engine crews and equipment, the safest
place for an attack to begin is from a(n): - answerburned area

An example of a polar solvent is: - answeracetone

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller julianah420. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for $14.99. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

67866 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy study notes for 14 years now

Start selling
$14.99
  • (0)
  Add to cart