Term 1 of 150
R4B08-02-05-01 The back flow prevention method consisting of two independent check valves
with an automatic operating pressure differential relief valve located between them is called:
Double check valve
Atmosphere vacuum breaker
Reduced pressure principle device
Precipitate dissolved solids
Term 2 of 150
ASME CSD-1 recommends that flame rods and scanners be replaced
annually
daily
quarterly
monthly
Term 3 of 150
Heavy oil recovered using SAGD or CSS is properly referred to as
kerogen
bottoms
tar
bitumen
,Term 4 of 150
(4-128-1.1) Which of the following is an advantage of medium and high pressure HVAC duct
systems?
Less costly fabrication and installation
Less physical space requirements
Lower operating cost
No need for costly noise suppression devices
Term 5 of 150
(4-143-2.11) "Barking", as it occurs in a pulp mill, means:
A method of communication used by pulp mill workers
The removal of bark from the logs
The sound made by a dog
A type of tree commonly found near pulp mills
Term 6 of 150
(4-059-1.4) The test lever on a safety valve must not be used unless the boiler:
Pressure is at least 75% of the valve popping pressure
The boiler is turned off
The test lever is rusty
The safety valve is malfunctioning
,Term 7 of 150
(4-074-1.3) Wear rings are usually constructed of:
Graphite or broze
Ceramics or aluminum
Steel or alloy steel
Bronze or cast iron
Term 8 of 150
(4-143-2.6) The raw material used in pulp and paper mills is:
Concrete
Steel
Wood
Metal
Term 9 of 150
R4B08-02-01-02 When the maximum building demand for potable water is always less than the
maximum flow available from a municipal or local distribution system, which of the following
systems can be used?
A tank-less constant pressure system
A robertson
A downfeed system
Its ability to rapidly start and carry full load
, Term 10 of 150
(4-128-2.1) A buried ventilation duct in an older building draws air from a chemistry lab fume hood.
The duct would likely be constructed of
Aluminum sheet metal
Galvanized steel sheet metal
Cement asbestos
Fiberglass
Definition 11 of 150
Prevent sewer gases from entering the building
R4B08-03-01-01 Traps are installed in sanitary drainage systems to
R4B07-03-02-01 The rate of heat transfer in any cooling tower system depends on the:
R4B05-03-03-01 When the fireside of a boiler is opened up, locations of water leakage may
be detected by:
R4B01-01-02-08 All semi-solid lubricants:
Term 12 of 150
R4B01-01-03-13 Lubricants used for high-output steam turbines should:
Be fire resistant
Have a very high viscosity
Have a low pour point
Mix well with water
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller stuuviaa. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $7.99. You're not tied to anything after your purchase.