Boilermaker test Questions And Answers With 100% Correct Answers
9 views 0 purchase
Course
Boilermaker
Institution
Boilermaker
The fumes produced during welding upon which of the materials listed below pose a health hazard -
Galvanized , carbon steel, stainless steel
During the air carbon arc cutting process , jets of compressed air are used to blow the slag away from the
cuts area. Which are the potential hazards durin...
Boilermaker test
The fumes produced during welding upon which of the materials listed below pose a health hazard -
Galvanized , carbon steel, stainless steel
During the air carbon arc cutting process , jets of compressed air are used to blow the slag away from the
cuts area. Which are the potential hazards during this process - Thermal burns, burning holes in
compressed air line, burnt shoes and clothing
What do you do with a socket that has cracks - Mark the socket with yellow paint and discard it
immediately
What is the tower man way used for - To enter the tower internally
The proper tightening sequence for a flange is a _______ pattern - Cross bolting
What wrench size do you use on 3/4 stud with heavy hex nuts - 1-1/4
When rigging valves , you should rig by the - Body
Where the hydrostatic testing goes - Bottom with the tiny circle and cross in a middle 2
Where is the man way - You enter in the hole-D
Bonnet bell head - The very top of the tower -8
When blinding a tower, what is the most preferred placement of the blinds - At first flagnge of the
tower, at the top of the tower, the easiest place to install them, or neither
A ring type joint (RTJ) flange would be used in a - High pressure pipe work system
, When hydro testing process equipment , where should the vent be located - At the highest point
allowed to relieve air pressure
What should be done when performing a first line break - Break away and down from you
Pass partition - Line in the middle of the bottom of the tower - 3
Channel head - Right side of the tower lower -10
Tubes - Middle of tower inside - 6
Davit - Skinny tube on the right side - B
Where are the bubble caps located - On the tray rings
The use of #9 wire as a socket retainer is permitted - False
The channel head cover and dollar plate are considered as the same terminology - True
What does the tray floor attach to - The tray ring
A process valve that automatically opens to prevent over pressure of a system is referred to as a -
Control
Floating head - Under bell head 9
Fixed tube sheet - 4 under tubes
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller ACADEMICMATERIALS. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $7.99. You're not tied to anything after your purchase.