100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
Previously searched by you
Previously searched by you
logo
General Contractor License - KB2 Study Prep - Full Set questions and correct answers (elaborations) with 100% accurate , verified , latest fully updated , 2024/2025 ,already passed , graded a+, complete solutions guarantee distinctions rationales| 5-star $7.99   Add to cart
Quickly navigate to
Preview
  2.  
  3. Commercial Construction
  4.  
  5. Commercial Construction

Exam (elaborations)

General Contractor License - KB2 Study Prep - Full Set questions and correct answers (elaborations) with 100% accurate , verified , latest fully updated , 2024/2025 ,already passed , graded a+, complete solutions guarantee distinctions rationales| 5-star

 7 views  0 purchase
  • Course
  • Commercial Construction
  • Institution
  • Commercial Construction

General Contractor License - KB2 Study Prep - Full Set questions and correct answers (elaborations) with 100% accurate , verified , latest fully updated , 2024/2025 ,already passed , graded a+, complete solutions guarantee distinctions rationales| 5-star rating

Preview 3 out of 20  pages

Document information

  • August 5, 2024
  • 20
  • 2024/2025
  • Exam (elaborations)
  • Questions & answers

Subjects

  • general contractor license kb2 study prep full

Written for

  • Commercial Construction
  • Commercial Construction

Seller

avatar-seller
AnswersCOM

Reviews received

Content preview

General Contractor License - KB2 Study Prep - Full
Set
.667 - ANS-The top of a 4 inch concrete slab is at one foot above the benchmark. What is the
elevation at the bottom of the slab?

"F" Channel - ANS-A kind of molding installed on the vertical wall used to accept aluminum soffit
panels is:

#6 - ANS-What is the minimum size screw for attaching gypsum board to steel studs?

#6 x 1 inch - ANS-What is the smallest sized screw that can be used to attach 1/2 inch gypsum
board to load bearing steel studs?

0.019 inch - ANS-Weep screeds shall be a minimum of _____ corrosion resistant weep screed
or plastic weep screed.

0.25 - ANS-What is the minimum thickness of fiber cement panel siding?

1 #4 reinforcing bar in top and bottom of footing - ANS-What is the minimum reinforcing bar
requirement for a slab-on-ground with turned down footings?

1 foot in 12 feet - ANS-The slope ratio of a handicap accessible ramp shall be a maximum of
_____.

1 inch - ANS-How much clearance is needed between the bottom of the roof sheathing and the
insulation for a cornice vent?

1 inch - ANS-What is the normal lap for bevel wood siding?

1 layer of # 15 - ANS-Asphalt shingles installed in warmer climates with a slope of 4 in 12 or
more should have a minimum underlayment of:

1 number 5 or two Number 4 bars in the middle third of the footing - ANS-A concrete
slab-on-ground cast monolithically with the footing shall be permitted to locate _____ as an
alternative to placement at the footing top and bottom?

1-1/2 by 3-1/2 - ANS-What is the actual size of a 2 x 4 surfaced dry piece of framing lumber?

1-1/2 inch - ANS-How large of a hole can be drilled into a steel stud?

,1-1/2 inch - ANS-The minimum depth of wire wall ties embedded in mortar of solid masonry unit
is?

1-1/2 inches - ANS-Nails used for installing Hardboard panel siding vertically must
accommodate the sheathing and penetrate the framing a minimum of how much?

1-1/4 inch - ANS-Steel wall framing track shall have a minimum flange width of _____?

1-1/4 inches - ANS-Tracks for structural steel framing shall have a minimum flange width of:

1-5/8 inches - ANS-Structural steel framing shall have a minimum flange width of:

1,087 sq. ft. - ANS-Refer to the illustration of a 2 story house w/lap siding plans, (complete set
of plans at the test center), How much siding is needed on the rear of the house? (Assume
using 6 inch siding with a 2 inch overlap, add 10% for waste and deduct 130 square feet for
doors and windows.)

1/16 inch - ANS-How close can your string line be to the cinder block wall you are building?

1/16 inch - ANS-If you are using a mason's line to build a wall, how far should the string be from
the wall?

1/2 inch - ANS-An untreated wood girder beam that sets in a pocket of a concrete foundation
wall that is subject to weather shall have a minimum air space of?

1/2 inch - ANS-The maximum slope for a horizontal drain and vent combination is _____ every
12 inches.

1/2 inch - ANS-Wall ties should be placed how far from the edge of a masonry unit?

1/2 inch - ANS-What is the thickest insulation panel that is allowed in an interior floor assembly?

1/3 acre - ANS-Refer to the illustration of a 2 story house w/lap siding plans, (available at the
testing center) How many acres is the site for the house plan?

1/4 - ANS-The maximum depth of a notch in the end of a floor joist is _____ of the depth of the
joist.

1/4 inch - ANS-How much clearance should be left between the ends of the panel and trim on
vinyl siding?

1/4 inch - ANS-What is the minimum size of a bed joint in a masonry wall at the foundation?

1/4 of depth - ANS-What is the maximum notch that is allowed at the end of a joist?

, 1/6 - ANS-According to the Code, notches allowed in the top or bottom of joists shall not exceed
what fraction of the depth of the joist?

1/6 - ANS-The maximum depth of a notch in the top or bottom of a floor joist is _____ of the
depth of the joist.

10 - ANS-A minimum tread run for stairways (other than spiral stairs) in single family dwellings
having an occupant load of less than 10 is _____ inches.

10 feet - ANS-A lot shall be graded to drain surface water away from foundation walls for a
minimum of _____ feet.

10 feet - ANS-How close to a plastic or canvas tarpulin can you place a portable heat source?

10 feet - ANS-The ground immediately adjacent to the foundation shall be sloped away from the
building at a slope of not less than 5 percent for a minimum of _____ feet

10 feet - ANS-What is the maximum allowable spacing between fire blocking in a concealed
wall?

10 to 12 cubic yards - ANS-Refer to the illustration of a 2 story house w/lap siding plans,
(complete set of plans at the test center), How many cubic yards of concrete would be required
for the footer only?

10.70 feet. - ANS-Given: Using a builder's level, the grade for a footing is being set. The bottom
of the footing will be at an elevation of 94.00. A back site to the bench mark (elevation of
100.00) has a rod reading of 4.70. If the grade is correct, the rod reading for the bottom of the
footing should be:

10% - ANS-What is the maximum slope of a footing trench before stepping is required?

12 - ANS-When installing brown cellulose insulation in an attic, how many inches of insulation
are needed to have a R38 if the R factor is 3.1 per inch?

12 inches - ANS-10 foot long planks used on scaffolding should not extend over the edges of
the support more than:

12 inches - ANS-According to code, what is the minimum required width of a footing in soil rated
at 2000 PSF for a single story building with 8 inch thick masonry walls?

12 inches - ANS-How much overlap should planks on scaffolding be that are not immovable?

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller AnswersCOM. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for $7.99. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

72349 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy study notes for 14 years now

Start selling
$7.99
  • (0)
  Add to cart