Exam (elaborations)
SOS brake & braking system Questions and correct answers | already graded a+ | verified answers
- Course
- Institution
SOS brake & braking system Questions and correct answers | already graded a+ | verified answers
[Show more]
Seller
Follow
AnswersCOM
Reviews received
Content preview
SOS brake & braking systemIn a single anchor bendix drum type rear brake - correct answer-the secondary lining is
longer than the primary
Compared to the secondary shoe lining areas of drum brakes, the primary shoe lining area
is: - correct answer-smaller and goes toward the front of the car
During a brake overhaul, you notice that the brake fluid seems to be very dirty and dark in
color. What should you do? - correct answer-flush the system before the new parts are
installed
In order to bleed the system on a vehicle equipped with power brakes: - correct
answer-None of the above
Which of the following could be a symptom of over-torqued lug nuts? - correct answer-A
brake pedal pulsation during braking.
Which of the following describes the proper sequence to bleed brake lines on most rear
wheel drive vehicles: - correct answer-RR, LR, RF, LF
In disc brake caliper assemblies, the "square cut seal" is usually located: - correct answer-In
the caliper piston bore
When performing a caliper overhaul, what would you use to remove the pistons from the
calipers? - correct answer-Compressed air
Sliding caliper disc brake pads are kept in adjustment by the - correct answer-Square cut
piston seal
A cracked or torn vacuum diaphragm in a power booster would likely cause: - correct
answer-Hard pedal with very high effort required
When the brakes are applied on a car with disc-drum brakes, a vibration or pulsating
movement is felt. What can cause this problem? - correct answer-A rotor thickness variation
While test driving a car, the mechanic finds that the right front brake "grabs". The most likely
cause of this problem is: - correct answer-Brake fluid or grease on the brake linings.
During a road test, you find that when normal breaking pressure is applied the pedal slowly
goes to the floor. What is the likely cause of this problem? - correct answer-A leaking master
cylinder primary piston seal.
A rattle is a single piston disc brake assembly which goes away when the brakes are applied
is most likely a result of: - correct answer-Loose pads in the caliper
, Which of the following would most likely cause dragging brakes? - correct answer-A
defective vehicle load sensor
With the car standing still, you can hear a squeaking noise when applying the brake pedal
slowly. What could cause this noise? - correct answer-Dry backing plate contact surfaces.
There is a scraping sound coming from one rear brake. The sound stops when the brakes
are applied. What is the likely cause of the problem? - correct answer-A broken shoe
hold-down spring or pin
If a drum brake self-adjuster seizes up, the likely result will be: - correct answer-A low pedal
Which of the following can be used to check for rotor thickness variation? - correct
answer-Dial indicator
On a vehicle with a disc/drum brake system, the rear wheels lock up under hard braking.
The most likely cause is: - correct answer-A defective proportioning valve
After putting a bearing race in a hub, you notice that the new race is loose and can spin in
the hub. What should you do? - correct answer-Replace the hub
When adjusting disc-drum brakes, you should: - correct answer-Adjust the rear brakes after
releasing the parking brakes
What type of rotor surface provides the best braking with new pads? - correct answer-A
smooth, flat surface
Which of the following is a quick way to determine whether the master cylinder is bad? There
are no external leaks in the system. - correct answer-Pump up the brake pedal, then hold it
firm. If the pedal slowly drops to the floor, the master cylinder is bad.
You are rebuilding a master cylinder. What should you use to lubricate the internal parts? -
correct answer-Brake fluid
Which of the following is the most likely cause of low fluid level in the master cylinder? -
correct answer-Worn brake pads and linings
After drum brakes have been applied and released, the brake fluid returns to the master
cylinder reservoir. What causes it to return? - correct answer-Brake shoe return springs
Which of the following describes the correct sequence for bleeding brake lines on most front
wheel drive vehicles? - correct answer-RR,LR, RF, LF
Technician A says that excessive pedal travel can be caused by low brake fluid levels;
Technician B says that the excessive pedal travel can be caused by air in the hydraulic
system? Who is right? - correct answer-Both A and B
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller AnswersCOM. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $11.49. You're not tied to anything after your purchase.
Can Stuvia be trusted?
4.6 stars on Google & Trustpilot (+1000 reviews)
79789 documents were sold in the last 30 days
Founded in 2010, the go-to place to buy study notes for 14 years now