Mechanics Exam Review-NEIEP Exam Questions And Verified Correct Answers Latest 2024 Update
A contractor wants to raise the car speed from 100 fpm to 125 fpm, it currently has a 12" sheave. What is required?
100 fpm/125 fpm= 12"/ X =15
A MOV (Metal Oxide Varistor) burns out. You replace it,...
A contractor wants to raise the car speed from 100 fpm to 125 fpm, it currently
has a 12" sheave. What is required?
100 fpm/125 fpm= 12"/ X =15
A MOV (Metal Oxide Varistor) burns out. You replace it, but cannot read voltage
or resistance. What should you do?
Replace it with a larger MOV - 630
On a Ward-Leonard circuit the brake is set, but the motor is trying to slip through
the brake. What is the issue?
Suicide Circuit - 425
You have an old DC motor and are adding an SCR drive, what do you do to the
interpoles?
Leave the interpoles alone. When adding a SCR drive to the generator, the series loop
is removed, as are the 3 resistors. Everything else remains the same
A hydro runs up with no load but will not run with a full load. What is the issue?
The relief valve is set too low - 815
Runby for a 1:1 hits the CWT buffer 4" below the top landing. CWT runby should
be set at 18". How much should the ropes be shortened?
22" - 235
You need to work on a freight door retiring cam, you LOTO the main line but there
is still power on the cam. What circuit is still hot?
Door Operator disconnect -535
,The contractor requests that the vertical center of a Rack and Pinion hoist be
moved. How do you do this?
Adjust tie downs and wall ties - 850
Working pressure on a Hydro is 400 PSI. What is the maximum relief valve
setting?
400 x 150%= 600 PSI - 815
What must be installed on a false care before operation?
Spring Loaded safeties - 110
There is slight arcing between the brush and commutator. What action must be
taken?
None
Note: Heavy arcing= light brush pressure, Heavy brush pressure= mechanical wear
If rigging is roped 3:1 and a BEAM CLAMP is used to lift a 6,000lb load. What is
the beam capacity?
18,000lbs -210
How much resistance is measured over a normally closed switch?
.2 Ohms- should be zero but will never be that low
A car traveling in the hoistway always stops at the same spot and blows a fuse.
What causes this?
traveling cable has a cut/exposed wire or a short - 515
How is a class 1 yearly buffer test preformed?
Car at the bottom landing and on inspection, jump out direction and final limits. With pit
clear, run down to compress the buffers, buffers should fully extend within 90 seconds.
Note: 5 yr is Full load, full speed - 555
How many strain supports are required on a 350 ft raceway?
4
1 every 100ft - 505-510
How is stainless steel drilled out?
Slow speed and constant pressure - 205
What is the required amout of retainer clips for wedge shackles and what is the
spacing?
, At least 2. First clip being 4 times the diameter of the rope from the top of the shackle,
and the second clip is 8 times the diameter of the rope away from the shackle. - 245
A 300 ohm resistor burns out, but you dont have another one. How can you make
one?
2- 600 ohms resistors in parallel is 300 ohms. Resistance is half of the highest resistor
in the parallel circuit. 3- 225 ohms is 75 ohms. - 345
When cutting laminated panels, which direction should the finish side face?
Finish side facing the cutting edge of the tool. Blade will burr the backside. - 225
How do you cut a finished floor?
Cutting blade away from the finished side - 255
A 480 VAC stepdown 240 VAC transformer is connected to a 3 phase rectifier,
what is the output voltage?
320 VAC
3 phase full wave= 1.33 x output voltage. - 715
A car is loaded with 125% and sinks, why?
Slipping through the brake
IF you find a broken or missing barricade what should you do?
Write up a formal inspection request
What are the consequences of misaligned joints on a rack and pinion?
Broken gear teeth. CWT derailment. Excessive wear/crease the surface of the tube. -
850
A dumbwaiter is 9 sqft in area, 4 ft in height, and capacity is 13.9lb/ft. What is the
total capacity?
9 X 4 x 13.9= 500lbs Max Capacity
You must enter a pit with a toxic atmosphere, how do you proceed?
Follow proper OSHA procedure with proper training and PPE - 133
When changing a 1:1 car rated at 600fpm and 2,000lb capacity to a 2:1, what are
the new ratings?
300 fpm with 4000lbs capacity. Half the speed and double the capacity.
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller LIXAN. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $8.99. You're not tied to anything after your purchase.
