Exam (elaborations)
Med gas exam questions with correct answers
- Course
- Institution
Med gas exam questions with correct answers
[Show more]
Content preview
Med gas exam questions with correct answersWhich of these three outdoor manifold enclosures are acceptable under the 2012 NFPA
99
Code?
Code?
a. X, Y, and Z
b. Y and Z only
c. Zonly
d. NFPA 99 does NOT state a requirement - Answer- C
Under which of these conditions shall the instrument air reserve header cylinders be permitted to be stored with the instrument air reserve header cylinders be permitted to be stored with the instrument air
a. The mechanical equipment room does NOT contain a boiler.
b. The medical air compressors are in the same room.
c. The only motor-driven machinery in the room is for the instrument air equipment.
d. The room is secured with lockable doors. - Answer- B
Riser valves are those valves located where?
a. Adjacent to the main riser downstream of any zone valve
b. Anywhere in the lateral branches of the piping system
c. In the main line adjacent to the base of the riser
d. In the riser adjacent to the main line - Answer- D
Installers of a Category 1 medical gas piped distribution system must be qualified in accordance with ASS: 6010. What is the certification requirement for installers of a Category 3 medical gas piped distribution system?
a. 6010
b. 6020
C.6030
d. Category 3 does NOT require certification. - Answer- A
When is the initial pressure test conducted by the Installer? a. After blow down of the distribution piping
b. After installation of alarm sensors
c. Before blow down of the distribution piping
d. Before installation of station rough-in assemblies - Answer- A
those portions of systems intended to handle oxygen at pressures greater than 350 psi, the interconnecting hose shall NOT containmaterials.
a. Brass
b. Copper
c. Polymeric
d. Stainless steel - Answer- Polymeric
The tool shown here allows the installer to mechanically limit the makeup depth of the fitting to be brazed. Under what conditions is this method permitted for the installation of
medical gas piping? - Answer- Where the limited make up depth is not less than minimum cup depth per ANSI/ASME recommendations
Refer to Diagram II:
Medical Air Intake Location. Choose the minimum height (feet) required from finished grade to the location at the capital letter "C'. (Diagram is not to scale.) - Answer- 20 feet
9. What is the standard gauge pressure (psi) for nitrogen gas service?
a. 15-30
b. 50-55
C. 160-185
d. Itvaries with the system type. - Answer- 160-186
10. Which of these is an NFPA 99 requirement for the labeling of pipes in a medical gas
system?
a. Color coding
b. Fixed label width
c. Label shall wrap completely around the pipe
d. Reflective label - Answer- Color coding
11. A wireless communication device is employed in a medical gas or vacuum waming system.
Which type of supervision is required for this device?
a. A visual indicator shall be located in the maintenance officer or the engineering department.
b. The device shall be installed at the medical gas or vacuum source.
c. The device shall be located at a nurse's station. d. The device will be supervised such that failure of communications shall initiate an alarm. - Answer- The device will be supervised such that failure of communications shall
initiate an alarm.
12. In a facility where medical gas or vacuum systems are present and the failure of such equipment or system is likely to cause imminent major injury or death to patients or caregivers, the system shall be designed to meet which Category of requirements? - Answer- 1
13. A facility is in the planning stages of installing an emergency oxygen service connection (EOSC).
How many feet is the minimum amount of clearance required around this connection?
a. 1 foot
b. 3 feet
c. 5 feet
d. Clearance must be 1-1/2 times the width of the auxiliary source for servicing the system.' - Answer- 3 feet
14. Refer to Diagram I:
What is the name of the valve depicted at #5?
a. In-line
b. Main
C. Riser
d. Source - Answer- In-line
15. Refer to Diagram I:
Identify #7.
a. Dead end
b. Future valve
c. History valve
d. Zone Valve - Answer- Zone valve
16. Refer to Diagram I:
Identify #8.
a. Dead end
b. Future valve
c. History valve
d. In-line Valve - Answer- Future valve
17: Which of the following conditions must be met where medical gas and vacuum systems are installed by non-certified personnel? a. An installer certified to ASSE 6010 must be present to oversee the installation work. b. An inspector certified to ASSE 6020 is present on the job site to inspect the installation work.
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller millyphilip. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $12.49. You're not tied to anything after your purchase.
Can Stuvia be trusted?
4.6 stars on Google & Trustpilot (+1000 reviews)
82215 documents were sold in the last 30 days
Founded in 2010, the go-to place to buy study notes for 14 years now