Exam (elaborations)
MK1 swe 672 QUESTIONS WITH COMPLETE SOLUTIONS LATEST 2024
- Course
- Institution
MK1 swe 672 QUESTIONS WITH COMPLETE SOLUTIONS LATEST 2024
[Show more]
Seller
Follow
supremetutor
Reviews received
Content preview
1MK1 swe| 672 QUESTIONS| WITH COMPLETE
SOLUTIONS LATEST 2024
When is the cutter engineering report due? - ANS Jan 31
What type of engine is on a P100 - ANS Single cylinder air cooled four stroke
How long will a P6 pump run on a tank of fuel - ANS 4 hours
What type of engine is on a P6 pump - ANS 6.5 horsepower Honda GX-200 has engine
How would you test 4-20 mA sensor - ANS In series
The MPU - 23 card exhibits what color lights on the panel when operating normally -
ANS Green Yellow Yellow
How many digits are in a NSN - ANS 13
What cut are R/G teeth? - ANS helical
Oil fog out of R/G - ANS Faulty precipitator
Standard hoses shall be identified as Standard in Hose Log and shall be scheduled for
replacement at intervals not to exceed - ANS 8 years
What % hydraulic failure is due to contamination? - ANS 80%
Hoses installed in the weather without an outer covering specifically designed for
service in the weather shall have a service life not to exceed - ANS 5 years
When using an ammeter to troubleshoot a system always use what - ANS The highest
scale
Small engine exhaust hose service life shall be in accordance with the hose
manufacturer recommendation or - ANS 5 years whichever is less
The most common type of media for coarse filtration is - ANS Surface media
What is the disadvantage of a centrifugal pump - ANS Suction lift
The shelf life for hoses and prefabricated hose assemblies shall not exceed - ANS 10
years
As wire size increases, what happens to resistance and amperage? - ANS Resistance
down - Amperage up
P a g e 1 | 35
,2
What does CAN stand for? - ANS Controller Area Network
What % of working pressure do you test a temp hose - ANS 150
How does a rise in the R/O input water temp effect the output temp - ANS Output
increases
What coolant is used in a keel cooler? - ANS antifreeze
At a modernized unit, where is your boat inspection report recorded? - ANS ALMIS
How often is the cutter engineering report conducted - ANS Yearly
Rudder stock is supported by what? - ANS bearing
Waster ring in the sea chest is for what? - ANS prevent galvanic corrosion
What is the acceptable leakage rate in a screw type hydraulic pump shaft seal - ANS
50ml
If you have a bearing failure in a centrifugal pump with excessive vibration, what is the
likely cause? - ANS misalignment
What causes aeration in a hydraulic system if there are no leaks? - ANS low fluid
You find something else is wrong with a piece of equipment already CASREPed what
should you send? - ANS Update
A thrust bearing supports what type of movement - ANS axial and radial
What does SSS stand for in a SSS clutch? - ANS Syncro-Self-Shifting
How is tin measured in a spectrometric oil analysis? - ANS ppm
If you find 40psi in a TANB trailer tire what type of discrepancy is it? - ANS restrictive
Where can DEMPS procedures be found? - ANS NEM-233-11
What type of fuel does a P100 run on - ANS F76 and JP5
When do you have zincs in freshwater - ANS Never
What is considered a hot surface on piping requiring flange shielding for LO - ANS 650
What is considered a hot surface on piping requiring flange shielding for FO - ANS 400
P a g e 2 | 35
,3
What happens to hydraulic oil for every 18 degrees it rises above 140 - ANS Oxidation
rate doubles
What type of o-ring is the most resistant to petroleum products - ANS Buna-S
Before you inflate a shaft seal what must you do first - ANS Stop and lock shaft
After an oil and filter change how many hours of engine operation should be allowed
before sampling - ANS 25 hours
Check amps on a non clamp ammeter - ANS In series
How is the boat record kept in a modernized unit - ANS EAL
What is the max thickening and dilution of L/O - ANS 40% thickening, 5% dilution
Oil intervals on a R/G - ANS 500 hours
what should the chlorine levels on the potable water shore tie be - ANS .02ppm for
15min or .02ppm for 30min
What date is placed on the hose tag - ANS Replacement
Jacket water is tested - ANS monthly
What type of fuel has FSII - ANS F44
what size safety chains are used on an rbs trailer - ANS 1/2"
What PMS does not show up in the Cutter engineering report - ANS Daily and weekly
Wet and dry bulb thermometer determines - ANS Humidity
What is the PSI for a medium service air system - ANS 151 to 1000 psi
Engineering casualty control is concerned with - ANS Prevention minimization and
correction of operational and battle casualties
Excessive property should be reported to - ANS Property officer
Which component can be pressure compensated or non pressured - ANS Flow control
valve
If a CAN buss has 120 ohm resistors at each end what is the total resistance on the
good CAN buss? - ANS 60 ohms
P a g e 3 | 35
, 4
What do you clean a battery terminal with - ANS Sodium Bicarbonate/ Ammonia
Where do you place a plastigauge - ANS Center
What are the 4 parts of a turbine - ANS Compressor, Combustor, Turbine, Auxiliary
What is the flashpoint of F-76? - ANS 140°
Smallest particle visible to the naked eye - ANS 40 microns
What will take hierarchy if manuals conflict - ANS NEM
Max leakage rate on a screw type pump - ANS 50 ml
When building an o ring what is the max stretch for inside diameter - ANS No more
than 10%
What is 1/8 as a decimal? - ANS 0.125
While test running BF225 Honda what is the Minimum voltage - ANS 12 volts
On a TANB Trailer, Tire Pressure below 40PSI - ANS Restrictive discrepancy
On a TANB trailer tire tread depth below 1/8" - ANS Restrictive discrepancy
When do you adjust the gap on an iridium spark plug - ANS Never
How long do you have to reset the DTC with the jumper installed (Honda) - ANS 20
seconds
What RPM does VTECH engage on a BF150 - ANS 4300 RPM
At what RPM does the VTEC Activate on a BF-225 - ANS 4500rpm
When low oil pressure is detected in a Honda what does it do - ANS Returns to idle
What tells you the a boat is safe to run in Almis - ANS Fully Mission Capable
what is a clear and bright test? - ANS Looking for water and sediment
When you increase wire diameter what happen - ANS Decrease resistance and
increase flow
How do you hook up a battery in parallel - ANS Positive to positive and negative to
negative
P a g e 4 | 35
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller supremetutor. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $25.49. You're not tied to anything after your purchase.
Can Stuvia be trusted?
4.6 stars on Google & Trustpilot (+1000 reviews)
79373 documents were sold in the last 30 days
Founded in 2010, the go-to place to buy study notes for 14 years now