Automotive Service Excellence(ASE) certification Bundle Set

Both b and c - Answer Coolant should be tested for ________. Proper color Freezing point (temperature) Specific Gravity Both b and c Both technician a and b - Answer Two technicians are discussing a compression test. Technician A says that the engine should be cranked over with the pres...

Spark plugs are being replaced on a v6 engine. Which of the following should be performed before removing the boot? - Answer Twist the boot 1/2 a turn Technician A days that a positive crankcase ventilation (pvc) system reduces vehicle emissions. Tech B says that a pvc system helps increase cra...

an engine miss is being diagnosed using a cylinder leakage test. Technician A says that any cylinder with over 20% leakage has excessive leakage. Tech B says that air leaking from the tailpipe indicates a cracked cylinder. A only, B only, A & B, Neither . - Answer A only: If cylinder l...

Three phases of aircraft ASE - Answer Avoiding detection Avoiding the engagement Surviving the engagement What is the best form of ASE on the aircraft? - Answer The aviator What is the primary means of avoiding the engagement? - Answer Reducing the aircraft's heat signature What ar...

Technician A says that when pressure testing a radiator cap, a special adapter is needed. Technician B says the best way to check thermostat operation is while it is in the engine. Who is right? - Answer Tech A A technician is checking resistance in an engine's spark plug wires using an ohmmet...

True or False. Chlorine was found to do damage to the ozone layer? - Answer True True or False. Different refrigerant are ok to be mixed together. Pressure characteristics are a little bit different but should not matter. - Answer False. High pressure characteristics between R12 and R134a var...

A - Answer A drum is chattering on the brake lathe. This could be the result of: A. Failure to install the dampening belt. B. Cutting too slowly. C. Dull cutting blades. D. Cutting speed too fast. C - Answer A vehicle is equipped with a hydro-boost brake system has a hard pedal with litt...

How would you adjust a rack yoke bearing? - Answer Tighten, then look at OEM specifications and back off by the suggested amount of degrees. If a customer states that their steering wheel turns more to the left than to the right, what are some of the most likely causes? - Answer - Incorrectly...

1. On a car with disc/drum brakes, the front brakes grab quickly when light pedal pressure is applied. This problem could be caused by a bad: A. proportioning valve B. pressure safety switch C. metering valve D. residual check valve - Answer 1. The correct answer is C. The metering valve del...

A spongy brake pedal may be caused by: a. ABS Diagnostic Trouble Code set b. Frozen caliper piston c. Defective metering valve. d. Air in hydraulic system - Answer D This question is not like the others. It has the word EXCEPT. For this question, look for the choice that could NOT cause th...

2. A driver says that the front end of his car vibrates up and down while traveling at most road speeds. Tech A says that too much runout of the front wheels could be the cause. Tech B says that a static out of balance of the front wheels could be the cause. Who is right? A. Tech A only B. Tech B ...

Which of following is not a common side effect associated with the use of steriods? - Answer sleeplessness Which of the following is not a motivation behind taking performance- enhancing drugs? - Answer Losing weight due to decreased appetite What is the most important thing to do before s...

Technician B says that Part 'X' is used to correct installed spring height. Who is right? - Answer B. Technician B only A compression test shows that one cylinder is too low. A leakage test on that cylinder shows that there is excessive leakage. During the test, air could be heard coming from...

How is voltage drop measure? A. Across a component with it operating B. Across a component with it not operating C. Both D. Neither - Answer A When measuring voltage drop what does it depend on A. Current B. Resistance C. Amps D. All the above - Answer B In a normal circu...