When is hose inspected - Study guides, Class notes & Summaries

NFPA 10 Exam 71 Questions with Verified Answers When should wheeled fire extinguishers be considered? - CORRECT ANSWER • High hazard areas are present. • Limited available personnel are present. Requiring: High agent flow rate, Increased agent stream range, increased agent capacity NON-DOT low pressure fire extinguisher cylinders that pass a hydrostatic test shall have the following recorded on a label: - CORRECT ANSWER • Month and year test was performed (perforated) • Test pre...

S-12 S-13 Standpipe and Sprinkler Practice Questions with Certified Solutions "Fail Safe" when referred to in locks, means that the door can be opened if the power fails Where does the on-duty Building Evacuation Supervisor report when an alarm is activated? To the Fire Command Station ( To act as Fire Safety Director when the FSD or a Deputy FSD is not required to be on duty). "RCNY" is the abbreviation for Rules of the City of New York A fire alarm box is painted plain red (no stripe). When...

General Maintenance/ Boma Questions and Answers 100% Pass When Starting a centrifugal pump That is part of a manifold with no check valves You should open the suction valve, start the pump and open the discharge valve slowly Curb cock A Valve insert it in a water line between the corporation stop and the water meter is generally called To check sheave wear Measure each groove angle Variable pitch sheaves may be used in some cases to provide which of the following types of speec...

Which load and carry works best when advancing hoseline up and down a stairway? - Answer-Minute man Which of the following will cause the upper layer of hot smoke and fire gases to contract toward the ceiling? - Answer-Steam formed in the upper layer of hot fire gases A short fold or reverse bend made in hose during the loading process is called a: - Answer-Dutchman How should a single firefighter heel the ladder when performing a one-firefighter extension ladder raise? - Answer-Against th...

Certificate of Fitness for Citywide Sprinkler Systems (S-12) S-12 CITYWIDE SPRINKLER SYSTEMS, S12 sprinkler test Spring 2023. THE __________ IS RESPONSIBLE TO MAINTAIN SPRINKLER SYS. AND TO DETERMINE QUALIFICATIONS. RECORDS OF ALL INSPECTIONS AND MX SHALL BE MAINTAINED ON PREMISES FOR A MIN. OF __________ YEARS. THE BUILDING OWNER SHALL ASSIGN A(N) ____________ TO COMPLY WITH REQUIREMENTS. REGULAR MX AND MINOR REPAIRS NOT AFFECTING MORE THAN ________ FLOOR(S) ARE CONSIDERED PLANN...

An outbreak of Salmonella is commonly associated with ______. - Undercooked poultry The restaurant staff noticed the health inspector coming in the door and assumed correctly they would be inspected. One of the employees quickly took the towel buckets, dumped them in a sink with dirty dishes, made fresh sanitizing solution, and put the towels back in the water. To their surprise, the inspector marked a violation. The violation was for _________. - Putting the soiled towels back in the new ...

FDNY S-92 Questions and Answers Rated A+ The following are types of what? LPG, CNG, piped natural gas or solid fuel (coke). Portable fueled salamanders/space heaters National Institute for Occupational Safety and Health (NIOSH) Recommended Exposure Limit (REL) for carbon monoxide 35 parts per million (ppm) over an 8 hour period What is the third leading cause of fires in buildings under construction ? temporary heating What is direct heat flow through matter? CONDUCTION What is the transport...

Z-51 Written Exam Questions and Complete Solutions In a steam turbine, what is the function of a Kingsbury thrust bearing? A) Maintain first stage steam pressure. B) Compensate for coupling misalignment. C) Adjust shaft torque at start up. D) Maintain axial positioning of the rotor shaft. - Answer: D) Maintain axial positioning of the rotor shaft. The ratio of actual pressure of water pressure in the atmosphere to the saturated pressure of given temperature is A) partial pressure....

ServSafe 7th Edition Diagnostic Test> 80-question diagnostic test and answer key (all correct updated 2022-2023.) The purpose of a food safety management system is to A) keep all areas of the facility clean and pest-free. B) identify, tag, and repair faulty equipment within the facility. C) prevent foodborne illness by controlling risks and hazards. D) use the correct methods for purchasing and receiving food. A manager's responsibility to actively control risk factors for foodb...

IFSTA 7th Edition - Chapter 12: Fire hose (Answered) Which type of hose transports water from the pumping apparatus to the nozzle where it is applied to the fire? (541) Attack hose A fire hose is labeled according to the: (541) Size of its inside diameter Which type of hose is designed to connect the pumping apparatus to a pressurized water source, such as a hydrant? (542) Large diameter soft sleeve hose Why is it advantageous for departments to use hose with national standard threaded ...