Nicet level 1 exam - Study guides, Class notes & Summaries

NICET LEVEL 1 EXAM 2024 ACTUAL EXAM COMPLETE 400 QUESTIONS WITH DETAILED VERIFIED ANSWERS (100% CORRECT ANSWERS) /ALREADY GRADED A+

When testing a water level supervisory switch serving a pressure tank a signal shall indicate if the water level _____________from the required level (NFPA 72, Table 14.4.3.2 17 (j) (4) Answer - rises or falls over 3 inches If combination audible/visible appliances are installed the location of the installed appliance shall be determined by the requirements of _______. (Nfpa 72 18.4.8.1) Answer - the visible appliance What is the maximum number of 12 gauge THHN wires that can be inst...

what is the maximum number of 14 AWG RHH conductors which can be installed in 1/2 rigid metal conduit? - Precise Answer 4 wires Which of the following would be an appropriate mounting height for a pull station? - Precise Answer 3.5'-48" to the actuator What is the minimum flash rate for a visible notification device? - Precise Answer 1 flash per second What is the minimum mounting height for audible notification devices? - Precise Answer 90" to the top of the device What is the mi...

NICET LEVEL 1 HIGHWAY CONSTRUCTION EXAM QUESTIONS AND ANSWERS Acceptance - Answer-The written acceptance by the Department of the Work. acceptance testing - Answer-Testing conducted by the Department to measure the degree of compliance to the Contract actual cost - Answer-The computed cost using calculations provided addendum - Answer-A Contract revision or response to a Contractor inquiry issued after advertisement and before the opening of bids. as-built quantity - Answer-The quantity ...

NICET Highway Construction Inspector Level III Practice Exam 1 (56 passed new update questions and answers) During installation of traffic loops in the pavement, which three statements apply prior to and during the installation of loop wire? (Choose 3). a) Do not allow vehicular traffic over an open saw cut. b) Do not overlap saw cuts at the corner. c) Thoroughly clean the saw cut of foreign material. d) Use a plastic sleeve where loop wire crosses a joint.

NICET Fire Alarm Level 1 Exam Questions and Answers (Latest Update 2023)

Nicet Level 1 water-based systems Practice Exam Questions and Answers 100% Pass What is a purpose of a control valve - Answer-Control Flow to water based fire protection system The gauge on the quick opening device shall indicate _____ as compared to the gauge on the system side of the dry pipe valve? - Answer-the same pressure What type of test shall be provided when a valve is returned to service to determine that the valve is open? - Answer-Valve status test What is a fire service mai...

NICET LEVEL 1 HIGHWAY CONSTRUCTION Exam Questions and Answers (Latest Update 2023) Verified Answers.

NICET Level 1 inspection and Testing Exam 2024 When using a pulse load tester on a sealed lead acid battery, the minimum acceptable capacity is... -Answer-80% When a software change is made to a fire alarm system, what percentage of the initiating devices not affected by the change must be tested -Answer-10% When testing elevator recall, the elevator should go to the alternate level when: -Answer-The lobby smoke detector on the recall level is activated Minimum requirement for system docu...

4 wires Answer - what is the maximum number of 14 AWG RHH conductors which can be installed in 1/2 rigid metal conduit? 3.5'-48" to the actuator Answer - Which of the following would be an appropriate mounting height for a pull station? 1 flash per second Answer - What is the minimum flash rate for a visible notification device? 90" to the top of the device Answer - What is the minimum mounting height for audible notification devices? Such that the entire lens is not less then 80...