ASE - Auto Maintenance and Light Repair Study Guide Questions with Answers.
0 view 0 purchase
Course
ASE G1
Institution
ASE G1
ASE - Auto Maintenance and Light Repair Study Guide Questions with Answers.
Technician A says that when pressure testing a radiator cap, a special adapter is needed. Technician B says the best way to check thermostat operation is while it is in the engine. Who is right? - Correct answer-Tech A...
ASE - Auto Maintenance and Light Repair Study
Guide Questions with Answers.
Technician A says that when pressure testing a radiator cap, a special adapter is needed.
Technician B says the best way to check thermostat operation is while it is in the engine.
Who is right? - Correct answer-Tech A
A technician is checking resistance in an engine's spark plug wires using an ohmmeter. A
general rule is to replace a wire if resistance is over: - Correct answer-30,000 ohms
Technician A says that in an ignition system, the voltage supplied to the coil during starting
is battery voltage. Technician B says the coil uses electromagnetic induction to create
high voltage. Who is right? - Correct answer-Both techs
A front wheel drive vehicle with an automatic transaxle has excessive vibration.
Technician A says that the vibration could be caused by worn engine/transaxle mounts.
Technician B says that the vibration could be caused by a misaligned engine/transaxle
subframe. Who is right? - Correct answer-Both techs
A technician suspects that a faulty camshaft sensor causes a driveability complaint. The
sensor is equipped with a three-wire connector. What type of sensor is this? - Correct
answer-a Hall effect type
All of the following can cause a problem in the Hydro-boost system EXCEPT:
A. loose power steering pump belt
B. leaking power steering hoses
C. low power steering pump pressure
D. leaking check valve - Correct answer-D
Technician A says that if a wire is getting too hot, it's a sign of higher-than-normal current
flowing through. Technician B says the wire would heat up if some of the individual strands
are broken inside the wire insulation. Who is right? - Correct answer-Both techs
Technician A says electrical connectors can be disconnected with the ignition switch ON,
as long as the technician is using a ground strap. Technician B says when welding on a
vehicle, the technician needs to use a static wrist strap. Who is right? - Correct answer-
Neither
Technician A says the thermostat maintains maximum engine operating temperature.
Technician B says if the engine continuously runs hot, install a cooler thermostat. Who is
right? - Correct answer-Neither
, A vehicle equipped with a MacPherson strut suspension is in the repair shop for new tires
and an alignment. The technician noticed that the vehicle has some play in the lift-side
inner tie-rod. What should the technician tell the customer?
A. It is not a problem that will affect alignment.
B. He can align the front end, but the tie-rod should be replaced soon
C. The inner tie-rod needs to be replaced before an alignment can be performed
D. He can set the vehicle alignment to compensate for the play in the inner tie-rod -
Correct answer-C.
An engine is losing coolant, yet has no external leaks. Technician A says to run the engine
and see if there is white smoke out of the exhaust. Technician B says to find out if the
engine's emission system uses a catalytic converter before running the test above. Who is
right? - Correct answer-both
LED bulbs can remain effective for up to how long depending on the size of the bulb and
the conditions to which the bulb is exposed? - Correct answer-15000 hours
All of the following should be performed during a preliminary transmission inspection
EXCEPT:
A. check transmission fluid level
B. visually check wiring and electrical connections
C. check the condition of the filter
D. check for fluid leaks - Correct answer-C
A smeary film on the windshield is an indication of:
A. evaporator core leak
B. water valve leak
C. heater core leak
D. restricted drain hose - Correct answer-C
Technician A says that all power should be removed from a circuit before testing the circuit
with an ammeter. Technician B says that all power should be removed from a circuit
before testing the circuit with an ohmmeter. Who is right? - Correct answer-Tech B
A rear wheel drive vehicle with a one-piece driveshaft has excessive driveshaft vibration
during low speed acceleration. Which of the following is the MOST likely cause?
A. binding U-joints
B. excessive driveshaft runout
C. driveshaft out of balance
D. improper driveshaft angle - Correct answer-D
When replacing an integral hub/bearing assembly on a front wheel drive vehicle, all of the
following must be removed EXCEPT:
A. brake rotor
B. brake caliper
C. steering knuckle
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller JayGracey. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $18.99. You're not tied to anything after your purchase.
