ASE G1 Test Prep (General Automobile Maintenance) Questions with Correct Answers.
1 view 0 purchase
Course
ASE A SERIES
Institution
ASE A SERIES
ASE G1 Test Prep (General Automobile Maintenance) Questions with Correct Answers.
Toe can cause tire wear if not within manufacturer's specifications
(True or False) - Correct answer-True
Camber can cause tire wear if not within manufacturer's specifications
(True or False) - Correct answer...
ASE G1 Test Prep (General Automobile Maintenance)
Questions with Correct Answers.
Toe can cause tire wear if not within manufacturer's specifications
(True or False) - Correct answer-True
Camber can cause tire wear if not within manufacturer's specifications
(True or False) - Correct answer-True
Caster can cause tire wear if not within manufacturer's specifications
(True or False) - Correct answer-False
Technician A says that a PAX run-flat tire uses a special wheel.
Technician B says that a standard tire can be used to replace a PAX run-flat tire.
Which technician is correct ? - Correct answer-Technician A only
Wheel back spacing is also called ? - Correct answer-Rear spacing
A tire is labeled 215/60R15 92T ; the 92 indicates what ? - Correct answer-Load rating
What do the letter "J J" mean in a wheel designation size labeled 14 x 7JJ - Correct
answer-The shape of the flange area
A tire is labeled 215/60R15 92T ; the T indicates what ? - Correct answer-Speed rating
When purchasing replacement tires, do not change tire width from the stock size by more
than ? - Correct answer-10 mm
Which type of disc brake caliper may leak brake fluid more often ? - Correct answer-Fixed
disc brake caliper
Brake fluid boiling point can be measured using ? - Correct answer-A Boiling Point Tester
What principle is used to create high voltage from low voltage? - Correct answer-
Electromagnetic induction
The Aspect Ratio of a tire means what ? - Correct answer-The ratio of height to width
The pickup coil or trigger is usually electrically connected to the ? - Correct answer-
Ignition Module
Semi-metallic brake pads are made by a process called ? - Correct answer-Sintering
Which of these takes place during regeneration in a Diesel Particulate Filter (DPF)? -
Correct answer-Soot is being burned
,The brake pad edge code letters "FF" mean what ? - Correct answer-Coefficient of
Friction Rating
Engine oil level should be checked .... - Correct answer-With the vehicle parked on level
ground
A quick-take-up master cylinder is required when what type of caliper design is used on a
vehicle ? - Correct answer-Low-Drag caliper
What part should be removed to test cylinder compression on a diesel engine? - Correct
answer-Glow plug or injector
Technician A says that maintenance-free batteries use a large amount of water.
Technician B says that maintenance-free batteries use materials that reduce the amount
of water used by the battery.
Which technician is correct? - Correct answer-Technician B only
What part causes the disc brake caliper piston to retract when the brakes are released ? -
Correct answer-The Square-Cut O-ring
Adding a chemical to make ethylene glycol bitter to the taste is called ? - Correct answer-
Embittered
All safety glasses should meet standards set by ? - Correct answer-ANSI (American
National Standards Institute)
A potentiometer, a three-wire variable resistor, is used in which type of sensor? - Correct
answer-Throttle Position Sensor (TPS)
Technician A says that galvanic activity is the result of a poor ground connection.
Technician B says that electrolysis can occur with a poor ground connection.
Which technician is correct? - Correct answer-Technician B only
Where is the fuel-pressure regulator located on a vacuum-biased port fuel-injection
system? - Correct answer-At the outlet of the fuel rail
Oil viscosity indicates what ? - Correct answer-Tendency of oil to resist flowing
Technician A says that with self-adjusting clutch systems, the release bearing constantly
rotates.
Technician B says the ball bearing portion of the release bearing should be lubricated with
high temperature grease during routine maintenance.
Which technician is correct? - Correct answer-Technician A only
Hydroplaning can occur at speeds as low as ? - Correct answer-30 mph
, Battery hold-down clamps or brackets help reduce ____________ , which can greatly
reduce the capacity and life of any battery. - Correct answer-Vibration
A starter can be constructed in a smaller size due to the use of ________________ and
permanent magnets. - Correct answer-Gear reduction
Two technician are discussing the need for history of the vehicle. Technician A says that
an accident could cause faults due to hidden damage.
Technician B says that some faults could be related to a previous repair.
Which technician is correct? - Correct answer-Both Technicians A and B
Technician A says the gear reduction occurs when the drive gear turns faster than the
driven gear.
Technician B says that overdrive occurs when the driven gear turns faster than the drive
gear.
Which technician is correct? - Correct answer-Both Technicians A and B
Technician A says that the cooling system should be tested for leaks using a pressure-
operated pressure pump.
Technician B says that the freezing and boiling point of the coolant can be tested using a
thermometer.
Which technician is correct? - Correct answer-Neither Technician A nor B
Technician A says that a wye-wound stator produces more maximum output than the
same alternator equipped with a delta-wound stator.
Technician B says than an alternator equipped with a delta-wound stator produces more
maximum output than a wye-wound stator. Which technician is correct? - Correct answer-
Technician B only
Technician A says that adjustable wrenches should be used when torquing fasteners.
Technician B says that adjustable wrenches can round the edges of fasteners.
Which technician is correct? - Correct answer-Technician B only
Polyglycol brake fluid is what color ? - Correct answer-clear/amber
Technician A says that the ASE tests are based mainly on General Motors Products.
Technician B says that the ASE exam has an essay portion that is graded by a panel of
experts.
Which technician is correct? - Correct answer-Neither Technician A nor B
Series wound electric motors produce maximum power at ? - Correct answer-0 RPM
The Environmental Protection Agency does not include corrosive materials in its
hazardous waste list published in the Code of Federal Regulation.
(True or False) - Correct answer-False
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller JayGracey. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $17.89. You're not tied to anything after your purchase.
