Exam (elaborations)
AMT Airframe Written Test (FAA)|1065 Questions and Answers
- Course
- Institution
AMT Airframe Written Test (FAA)|1065 Questions and Answers
[Show more]
Content preview
AMT Airframe Written Test (FAA)|1065 Questions and Answers
C- detection. - -5 (9001) - Smoke detection instruments are classified by
their method of
- B- Cockpit and/or cabin. - -1 (8997) - In what area of an aircraft would you
find a carbon monoxide detector?
- B- A lamp within the indicator illuminates automatically - -2 (8998) - What
occurs when a visual smoke detector is activated?
- A- water, carbon dioxide, dry chemical, and halogenated hydrocarbons - -3
(8999) - The types of fire-extinguishing agents for aircraft interior fires are
- B- Green. - -4 (9000) - When air samples contain carbon monoxide,
portable carbon monoxide detectors containing yellow silica gel will turn
which color?
- B- photoelectrical devices. - -6 (9002) - Smoke detectors which use a
measurement of light transmissibility in the air are called
- B- installing a new indicating element. - -7 (9003) - A contaminated carbon
monoxide portable test unit would be returned to service by
- C- Thermocouple. - -8 (9004) - Which fire-detection system measures
temperature rise compared to a reference temperature?
- A- horn is nonmetallic. - -9 (9005) - A carbon dioxide (CO(2)) hand-held fire
extinguisher may be used on an electrical fire if the
- C- dry powder chemical. - -10 (9006) - The proper fire-extinguishing agent
to use on an aircraft brake fire is
- B- Photoelectric cell. - -11 (9007) - Smoke in the cargo and/or baggage
compartment of an aircraft is commonly detected by which instrument?
- B- senses light reflected from smoke particles passing through a chamber -
-12 (9008) - Light refraction smoke detectors are activated when the
detector
- C- A short may exist in either circuit without causing a false fire warning. -
-13 (9009) - Why does the Fenwal fire-detection system use spot detectors
wired parallel between two separate circuits?
, - B- weighing the container and its contents. - -14 (9010) - A fire-
extinguisher container can be checked to determine its charge by
- A- Brown. - -15 (9011) - What is the color code for fire-extinguisher lines?
- C- dents, kinks, or crushed sensor sections. - -16 (9012) - The most
common cause of false fire warnings in continuous-loop fire-detection
systems is
- A- it generates a small current when heated. - -17 (9013) - A thermocouple
in a fire-detection system causes the warning system to operate because
- C- rate-of-temperature rise. - -18 (9014) - The thermocouple fire-warning
system is activated by a
- A- parallel with each other and in series with the light. - -19 (9015) - When
used in fire-detection systems having a single indicator light, thermal
switches are wired in
- B- halogenated hydrocarbons and nitrogen - -20 (9016) - Built-in aircraft
fire-extinguishing systems are ordinarily charged with
- B- both No. 1 and No. 2 are true. - -21 (9017) - In reference to aircraft fire-
extinguishing systems,(1) during removal or installation, the terminals of
discharge cartridges should be grounded or shorted.(2) before connecting
cartridge terminals to the electrical system, the system should be checked
with a voltmeter to see that no voltage exists at the terminal
connections.Regarding the above statements,
- B- A rupture of the red plastic disk in the thermal discharge line. - -22
(9018) - What method is used to detect the thermal discharge of a built-in
fire-extinguisher system?
- B- parallel with each other, but in series with the indicator lights. - -23
(9019) - The thermal switches of a bimetallic thermal-switch type fire-
detection (single-loop) system are heat-sensitive units that complete circuits
at a certain temperature. They are connected in
- C- 45 to 73°F. - -24 (9020) - (Refer to Figure 21.) Using the chart,
determine the temperature range for a fire-extinguishing agent storage
container with a pressure of 330 PSIG. (Consider 330 PSIG for both minimum
and maximum pressure.)
, - A- 215 to 302 PSIG. - -25 (9021) - (Refer to Figure 21.) Determine what
pressure is acceptable for a fire extinguisher when the surrounding area
temperature is 33°F. (Rounded to the nearest whole number.)
- B- Replace the extinguisher container. - -26 (9022) - On a periodic check
of fire-extinguisher containers, the pressure was not between minimum and
maximum limits. What procedure should be followed?
- C- yellow disk on the side of the fuselage. - -27 (9023) - In some fire-
extinguishing systems, evidence that the system has been intentionally
discharged is indicated by the absence of a
- B- used only on the original discharge valve assembly. - -28 (9024) - If a
fire extinguisher cartridge is removed from a discharge valve, it should be
- C- 1, 2, 3, and 4. - -29 (9025) - Which of the following are fire precautions
which must be observed when working on an oxygen system?1. Display 'No
Smoking' placards2. Provide adequate fire-fighting equipment.3. Keep all
tools and oxygen servicing equipment free from oil or grease.4. Avoid
checking aircraft radio or electrical systems.
- B- Bromotrifluoromethane (Halon 1301). - -30 (9026) - Which fire-
extinguishing agent is considered to be the least toxic
- C- replacement of damaged sensing elements. - -31 (9027) - Maintenance
of fire-detection systems includes the
- B- device for causing the fire-extinguishing agent to be released. - -32
(9028) - A squib, as used in a fire-protection system, is a
- A- remove all paint from the area to be covered by the deicer boot. - -1
(8969) - Prior to installation of a pneumatic surface-bonded type deicer
boots, on the leading edge of the wing, you should
- C- 1, 2, 3, 5. - -2 (8970) - Which of the following are found in a laminated
integral electrically heated windshield system?1. Autotransformer.2. Heat
control relay.3. Heat control toggle switch.4. 24V dc power supply.5.
Indicating light.
- A- Ammeter reading. - -3 (8971) - What is one check for proper operation
of a pitot/static tube heater after replacement?
- C- Distributor valve. - -4 (8972) - What controls the inflation sequence in a
pneumatic deicer boot system?
, - A- Vane-type pump. - -5 (8973) - What is the source of pressure for
inflating deicer boots on reciprocating engine aircraft?
- C- Suction relief valve. - -6 (8974) - Which of the following regulates the
vacuum of the air pump to hold the deicing boots deflated when the
pneumatic deicing system is off?
- C- Soap and water. - -7 (8975) - What may be used to clean deicer boots?
- C- Whenever icing conditions are first encountered or expected to occur. -
-8 (8976) - Some aircraft are protected against airframe icing by heating the
leading edges of the airfoils and intake ducts. When is this type of anti-ice
system usually operated during flight?
- B- Fluctuating readings on the pressure gauge and relatively steady
readings on the vacuum gauge. - -9 (8977) - Which of the following
indications occur during a normal operational check of a pneumatic deicer
system?
- A- Thermo-cycling switches. - -10 (8978) - What method is usually
employed to control the temperature of an anti-icing system using surface
combustion heaters?
- B- To sequence the deicer boots inflations symmetrically. - -11 (8979) -
What is the purpose of the distributor valve in a deicing system utilizing
deicer boots?
- A- To protect the deicer boots from oil deterioration. - -12 (8980) - What is
the purpose of the oil separator in the pneumatic deicing system?
- A- Imbedded in the glass. - -13 (8981) - Where are the heat sensors
located on most aircraft with electrically heated windshields?
- B- compressor bleed air and aircraft electrical system. - -14 (8982) - Two
possible sources of heat for the operation of a wing thermal anti-icing system
are
- B- Thermistors. - -15 (8983) - What maintains normal windshield
temperature control in an electrically heated windshield system?
- C- conductive coating. - -16 (8984) - Arcing in an electrically heated
windshield panel usually indicates a breakdown in the
- C- Distributor valve. - -17 (8985) - Which of the following connects vacuum
to the deicer boots when the system is not in operation, to hold the boots
tightly against the leading edges in flight?
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller Nursephil2023. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $20.49. You're not tied to anything after your purchase.
Can Stuvia be trusted?
4.6 stars on Google & Trustpilot (+1000 reviews)
77254 documents were sold in the last 30 days
Founded in 2010, the go-to place to buy study notes for 14 years now