24 hours - answer An event reporting form must be submitted for a system disturbance
that meets NERC criteria for reporting and must be completed with in
Take snapshot of system, adjust system model, run AC on Study - answer The power
flow tool provides the system operator with the ability to do which of the following
Call EMS Support personnel to get SE running - answer If State Estimator fails to solve,
what should the system operator take
Contingency Analysis can be run on the results of Study Power Flow - answer what is
the relationship between the Study Power Flow program and Contingency Analysis?
an internal generator trip - answer If your system is experiencing high system loads,
high system imports, and transmission facilities loaded to 100%, which of the following
situations would make the situation worse
SE runs first and then CA runs suing the results of SE - answer which of the following
best describes the sequence of State Estimator and Contingency Analysis
CA uses the results of SE to solve - answerWhich of the following statements is ture
about the relationship between State Estimator and Contingency Analysis
150 MW - answerA transformer has a .8 or 80% power factor and has 150 MW flowing
out on its high side. How many MWs are flowing into the low side?
a. 187.5 MW
b. 150 MW
c. 120 MW
d. 37.5 MW
c. 50 - answerYour frequency bias is -100 MW / .1Hz. System frequency is 59.95. How
much is your balancing authority contributing to the Interconnection.
a. 100 MW
c. 50 MW
b. 75 MW
d. 30 MW
, d. A condition of abnormal electric current which causes protective relays to operate -
answerA fault has occurred in your power system. What will the System Operator look
for?
a. A condition where a component is not in sync with the rest of the system
b. A condition that causes a device, component, or element to fail
c. A condition of abnormal electric current
d. A condition of abnormal electric current which causes protective relays to operate
a. Generators - answerWhat makes up spinning reserves?
a. Generators
b. Synchronous condensers
c. Capacitors
d. Reactor
c. Power Losses - answerWhat does I2R indicate?
a. Voltage
b. Resistance
c. Power Losses
d. Transformers
a. Inertia - answerWhat resists an initial decline in system frequency following a
disturbance?
a. Inertia
b. AGC
c. AVR
d. Frequency Bias
c. Tie Line Bias - answerWhat is the primary AGC control mode that will best indicate a
Balancing Authorities generation-load-interchange balance?
a. Generators on Auto
b. Flat Interchange control
c. Tie Line Bias
d. Constant Frequency
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller julianah420. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $14.49. You're not tied to anything after your purchase.