______ shall be permitted to be concealed within walls, floors and ceilings were the walls, floors and ceilings provide a thermal barrier material which has at least one hour finish reading as identified in listing of fire rated assemblies. - ANSWERENT
_____________ motors are permitted as contr...
______ shall be permitted to be concealed within walls, floors and ceilings were the walls, floors and
ceilings provide a thermal barrier material which has at least one hour finish reading as identified in
listing of fire rated assemblies. - ANSWERENT
_____________ motors are permitted as controllers. - ANSWERPortable
________________ shall clearly indicate whether they are in the open off or closed on the position
where circuit breaker handles are Operated vertically rather than rotationally or horizontally the
opposition of the handle shall be the on position. - ANSWERCircuit Breakers
__________________________shall be secured by hardware including straps, cable ties, hangers or
similar fittings designed and installed so as not not damage the cableZ - ANSWEROptical fiber cables
_______________fuse holders and adapters shall be design so that either the fuse holder itself or
the fuse holder with the type S adapter inserted cannot be use for any fuse other than a type S Fuse.
- ANSWERType S
_____________shall be permitted to be installed without the air space on the concrete, Masonary,
tile or similar surface. - ANSWERNonmetallic enclosures
__________fuses Shall be of the plug type in shell comply with 240.53 A,B - ANSWERType S
__________is term indicating that there is an intentional delay in the tripping action of the circuit
breaker which decreases as the magnitude of the current increases. - ANSWERInverse time
_________is a Bus way used To connect from the service point to the line terminals of the service
equipment. - ANSWERService busway
________Shall be permitted to be installed embedded in poured concrete. - ANSWERENT
,________Shall be permitted to be installed in wet location indoors or in a concrete slab on her below
grade with fittings listed and approved for the purpose - ANSWERENT
_______shall be permitted to be installed above suspended ceilings with a suspended ceilings
provide a thermal barrier of material which has at least one hour finish reading as identified in
listings of fire rated assemblies. - ANSWERENT
110.26 A1- Dead front assemblies working space - ANSWER30" for non-electrical parts
36" for electrical parts
A _______ is not considered a power supply - ANSWERCapacitor
A ____________________ of the photovoltaic system must be made available upon request of the
department. - ANSWERDetailed diagram
A ______________________ shall submit to the department a testing report of the completed
system upon installation from an authorized testing entity. - ANSWERLicensed professional
A 125 V single phase 15 or 20 amp rated receptacle outlet shall be installed at an accessible location
for the servicing of heating air-conditioning and refrigeration equipment the receptacle shall be
located on the same level and within _______of the heating air-conditioning and refrigeration
equipment the receptacle outlet shall not be connected to the load side of the equipment
disconnecting means. - ANSWER25 feet
A branch circuit that supplies only one utilization equipment is a ______branch circuit. -
ANSWERIndividual
A detailed diagram of the ______________ system must be made available upon request of the
department. - ANSWERPhotovoltaic
A fence shall not be less than ______feet in height - ANSWER8 feet
A general care patient bed location served from 2 seperate transfer switches on the emergency
system shall not be required to have circuits from the ___________ system. - ANSWERNormal
,A hospital is a building or portion thereof used on a 24 hour basis for medical, psychiatric, obstetrical
or surgical care of ______ or more inpatients. - ANSWER4
A limited care facility is an area used on a 24 hour basis for the housing of 4 or more patients who
are _______________________. - ANSWERIncapable of sef preservation
A load demand factor of 75% is permitted for _____ or more appliances fastened in place such as
waste disposal's, dishwashers, trash compactor's, water heaters, etc. - ANSWER4
A load of not less than ______volt amperes shall be included for each to wire laundry branch circuit.
- ANSWER1500
A luminaire shall be installed so that combustible material is not subjected to temperatures in excess
of _________ degrees C. - ANSWER90
A receptacle connected to one of the dwelling unit small appliance branch circuits cab be used to
supply a(n) ______________ in any of the rooms specified in 210.52 B 1. - ANSWERRefrigerator
A receptacle connected to one of the dwelling unit small appliance branch circuits can be used to
supply a _____________ in any of the rooms specified in 210.52B1 - ANSWERRefrigerator
A receptacle connected to one of the dwelling unit small appliance branch circuits can be used to
supply a(n) __________in any of the rooms specified in 210.52B1. - ANSWERElectric clock
A seperation of at least ____ inches is required between network communication cable and power
cables. - ANSWER4
A seperation of at least _________ feet shall be maintained between communications wires and
cables on buildings and lightning conductors, where practiceable. - ANSWER6
A service switchboard size over 5000 A with a 100% rating shall have copper bus bar size on an
ampacity of ________per square inch. - ANSWER700 A
A storage battery supplying emergency lighting and power shall maintain not less than 87.5% of full
voltage at total load for a period of at least ________ hours. - ANSWER1.5
, Abandon CATV cables shall be be ______. - ANSWERRemoved
Abandon communication circuits shall be ___________________. - ANSWERDe-energized
Abandoned cables, power sources and other special equipment not tagged for future use shall be
_______________________. - ANSWERDe-energized
Acceptance test- A __________________ shall submit to the department a testing report of the
completed system upon installation from an authorized testing entity. - ANSWERLicensed
professional
Access openings in a manhole shall not be less than _________ inches. - ANSWER26
Access to manhole dimensions. Rectangular access openings shall not be less than _______. Round
access openings in a manhole shall be not less than ______inches in diameter - ANSWER26" x 22"
26"
Accessible non-current carrying metal parts of central vacuum assemblies are required to be
connected to a(n) ____________________. - ANSWEREquipment grounding conductor
Accessible non-current carrying metal parts of the central vacuum outlet assembly shall be
connected to ______________________________. - ANSWERAn equipment grounding conductor
Accessible noncurrent caring metal parts are required to be connected to an equipment grounding
conductor for ____________ outlet assemblies - ANSWERCentral vacuum
All Lumineers install in wet locations shall be marked - ANSWERSuitable for wet locations
All non-current carrying metal parts of electrical equipment and all metal raceways and cable shall be
solidly grounded and bonded to all metal pipes in rails at the portal and the intervals not exceeding
_____________throughout the tunnel. - ANSWER1000 feet
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller ClassRep2. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $13.49. You're not tied to anything after your purchase.
