CTS - International Operations Questions And Answers Rated A+ New Update Assured Satisfaction
10 views 0 purchase
Course
CTS - International Operations
Institution
CTS - International Operations
Where may significant international information and data affecting the use of foreign or international
airspace, such as temporary changes or permanent changes that have not been published in other
permanent sources, be found? - The International Notice to Airmen (IN).
Annex 5, Units of Measurem...
CTS Exam Study Cards
Which type of server automatically assigns an IP address to the MAC address during the device's
connection to a network? - A DHCP server automatically assigns an IP address to the MAC address
during the device's connection to a network.
What should be the specific capabilities of the AV systems defined in the program report/concept design
report be based on? - Identified needs of the end user
While evaluating a potential AC conference room site, you notice the HVAC system appears to be
introducing a substantial amount of noise into the environment. What should be your first course of
action? - Ask to obtain measurements of the HVAC noise using a SPL meter (A Weighted). Record
the measurements and provide them to the design team to articulate the implications to the client's site.
When working with a client to design an AV solution for a new conference center, the client requests a
detailed budget for the equipment and installation. In what project phase does this occur? -
Design Phase
AV Specialists determine the end users needs by examining three things: the required applications, the
tasks, and .... - Function of the applications
When verifying a display system, what should be used to determine whether it meets a specified
contrast ratio? - Spot Photometer
A simple dimmer rack is feeding 24 incandescent lights during a stage production. The rack is running on
a steady 230v AC supply and averaging a current draw of approximately 98 amps. Suddenly the line
voltage drops to 211v AC. Calculate the expected draw at this new voltage. - 90 Amps
The question is to test familiarity with Ohm's Law and the relationships between voltage, current, and
resistance. If the voltage decreases but the load remains constant, than the current must also decrease.
,So if the voltage falls from 230 to 211 volts than the current must fall proportionately. As 211/230=.92
the current drawn will be 98x.92=90.16(90 amps), **Note that incndescenet lamps are a resistive load,
not a constant power load such as an amp or a projector. The answer would be different with a constant
power device.
For what purpose would an AV tech designate a loop back internet protocol address in the range of
127.0.0.1 to 127.255.255.254 in network configuration? - To test the local device to see whether
TCP/IP is working on the system.
In the needs analysis pyramid, what is used to define tasks that will be used to define the scope of the
project? - Applications
The minimum load safety rating for mounting audiovisual equipment is.... - 5:1
When establishing initial contact with a client, try to develop a relationship early on with the.... -
stakeholders
The document that is presented to the end user as a summary of the need analysis and site survey is
called the ..... - Program Report/Concept Design Report
The minimum load safety rating for mounting audiovisual equipment is... - 5:1
In a digital signal, the on state is represented by...., and the off state is represented by.... - One;
Zero
The audio signal ends up in an....before being converted into acoustical energy. - Output Device
What is crossover? - an electrical frequency dividing network circuit.
Electromagnetic radiation is categorized by its.... - Wavelength
,Illumination decreases by....when the distance from a light source is doubled. - 75%
To measure bandwidth of an image, you will need a.... - Spectrum Analyzer
The....the gain number of projection screen, the....the image. - The higher the gain number of a
projection screen the brighter the image.
Which IEEE standard defines Wi-Fi communications methods? - The IEEE 802.11 standard defines
wifi communication methods.
What is required to set an IP address manually on a network? - An IP address and subnet mask are
required to set an IP address manually on a network
What differentiates a cable from a wire? - Cable contains multiple conductors
Unless amplified or buffered, digital signals generally do not travel as far as ....signals - analog
signals
What do switchers do? - Switchers allow the user to select one input from a number of inputs
The inside of a typical AV rack is...wide, and the outside varies from.... - The inside of a typical AC
rack i 19 inches (482.6mm)wide, and the outside varies from 21 to 25 inches(533 to 635mm).
Power is measured in.... - Power is measured in watts
The reationship between voltage, current, and resistance is defined by the formula.... - The
relationship between voltage, current, and resistance is defined by the formula, I=V/R
, The main panel distributes power using...... - The main panel distributes power using feeders and
distribution panels.
An AC signal of...falls into the RF spectrum. - An AC signal of 3kHz to 300GHz falls into the RF
spectrum
What does a transmitter do with its incoming signal stream? - modulates its incoming signal
stream to be sent out via antenna
One of the most efficient configurations for a vertical antenna is to.... - One of the most efficient
configurations for a vertical antenna is to have a physical length 1/4 of the signal wavelength
Parabolic antennas are ideal for use in... - Parabolic antennas are ideal for use in point to point
communications
How does knowledge of the overall room function assist the AV system designer in defining the client
needs? - Knowledge of the overall room function assists the AV system designer by providing a
starting point from which to determine client needs.
How does the AV team use information about any identified constraints to the AV design and installation
tasks? - The AV team uses information about any identified constraints to the AV design and
installation tasks to develop a work-around plan when these constraints will affect the design or
installation tasks.
What type of plan drawing depicts the layout of items on the ceiling? - Reflected ceiling plans
depict the layout of items on the ceiling.
What type of drawing would you use to determine what is behind a wall or above a ceiling that could
interfere with your system installation plan? - Section Drawings depict the structures behind a
wall or above a ceiling that could interfere with your system installation plan.
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller ACADEMICMATERIALS. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $7.99. You're not tied to anything after your purchase.
