General Exam AVMT UPDATED Exam Questions and CORRECT Answers
7 views 0 purchase
Course
AVMT
Institution
AVMT
General Exam AVMT UPDATED Exam
Questions and CORRECT Answers
The working voltage of a capacitor in an AC circuit should be - CORRECT ANSWER- at
least 50 percent greater than the highest applied voltage
The term that describes the combined resistive forces in an AC circuit is - CORRECT
ANSWE...
General Exam AVMT UPDATED Exam
Questions and CORRECT Answers
The working voltage of a capacitor in an AC circuit should be - CORRECT ANSWER- at
least 50 percent greater than the highest applied voltage
The term that describes the combined resistive forces in an AC circuit is - CORRECT
ANSWER- impedance
The basis for transformer operation in the use of alternating current is mutual - CORRECT
ANSWER- inductance
The opposition offered by a coil to the flow of alternating current is called (disregard
resistance) - CORRECT ANSWER- inductive reactance
An increase in which of the following factors will cause an increase in the inductive
reactance of a circuit? - CORRECT ANSWER- Inductance and frequency
When different rated capacitors are connected in series in a circuit, the total impedance is -
CORRECT ANSWER- less than the capacitance of the lowest rated capacitor
Capacitors are sometimes used in DC circuits to - CORRECT ANSWER- smooth out slight
pulsations in current/voltage
In an AC circuit, the effective voltage is - CORRECT ANSWER- less than the maximum
instantaneous voltage
The amount of electricity a capacitor can store is directly proportional to the - CORRECT
ANSWER- plate area and inversely proportional to the distance between the plates
What is the total capacitance of a circuit containing three capacitors with a capacitance of .02
microfarad, .05 microfarad, and .10 microfarad, respectively? - CORRECT ANSWER- .0125
uF
,Unless otherwise specified, any values given for current or voltage in an AC circuit are
assumed to be - CORRECT ANSWER- effective values
When different rated capacitors are connected in parallel in a circuit, the total capacitance is -
CORRECT ANSWER- equal to the sum of all the capacitances
When indicutors are connected in series in a circuit, the total inductance is - CORRECT
ANSWER- equal to the sum of the individual inductances
When more than two inductors of different inductances are connected in parallel in a circuit,
the total inductance is - CORRECT ANSWER- less than the inductance of the lowest rated
inductor
What is the total capacitance of a certain circuit containing three capacitors with capacitances
of .25 microfarad, .03 microfarad, and .12 microfarad, respectively? - CORRECT ANSWER-
.4 uF
Which requires the most electrical power during operation? - CORRECT ANSWER- Two
lights requiring 3 amps each in a 24-volt parallel system
How much power must a 24-volt generator furnish to a system which contains the following
loads?
One motor 75% 1/5 HP
Three position lights 20W each
One heating element 5 amp
One anticollision light 3 amp
(Note: 1 horsepower = 746 W) - CORRECT ANSWER- 450 Watts
A 12-volt electric motor has 1,000 watts input and 1 horsepower output. Maintaining the
same efficiency, how much input power will a 24 volt, 1 horsepower electric motor require? -
CORRECT ANSWER- 1,000 watts
,How many amperes will a 28-volt generator be required to supply to a circuit containing five
lamps in parallel, three of which have a resistance of 6 ohms each and two of which have a
resistance of 5 ohms each? - CORRECT ANSWER- 25.23 amperes
A 1-horsepower, 24-volt DC electric motor that is 80% efficient requires 932.5 watts. How
much power will a 1 hp, 12V DC electric motor that is 75% efficient require? - CORRECT
ANSWER- 994.6 Watts
The potential difference between two conductors which are insulated form each other is
measured in - CORRECT ANSWER- Volts
A 24V source is required to furnish 48W to a parallel circuit consisting of four resistors of
equal value. What is the voltage drop across each resistor? - CORRECT ANSWER- 24V
When calculating power in a reactive or inductive AC circuit, the true power is - CORRECT
ANSWER- less than the apparent power
What is the impedance of an AC-Series circuit consisting of an inductor with a reactance of
10 ohms, a capacitor with a reactance of 4 ohms, and a resistor with a resistance of 8 ohms? -
CORRECT ANSWER- 10 Ohms
The correct way to connect a test voltmeter in a circuit is - CORRECT ANSWER- in parallel
with a unit
Which term means .001 ampere? - CORRECT ANSWER- Miliampere
A cabin entry light of 10 watts and a dome light of 20 watts are connected in parallel to a 30-
volt source. If the voltage across the 10-watt light is measured, it will be - CORRECT
ANSWER- equal to the voltage across the 20-watt light
A 14-Ohm resistor is to be installed in a series circuit carrying .05 ampere. How much power
will the resistor be required to dissipate? - CORRECT ANSWER- At least 35 milliwatts
.002KV equals - CORRECT ANSWER- 2.0 Volts
, A 24V source is required to furnish 48W to a parallel circuit consisting of two resistors of
equal value. What is the value of each resistor? - CORRECT ANSWER- 24 Ohms
Which required more electrical power? - CORRECT ANSWER- A 1/5 hp, 24V motor which
is 75% efficient
What unit is used to express electrical power? - CORRECT ANSWER- Watts
What is the operating resistance of a 30W light bulb designed for a 28V system? - CORRECT
ANSWER- 26Ohms
Which statement is correct when made in reference to a parallel circuit? - CORRECT
ANSWER- The total current is equal to the sum of the currents through the individual
branches of the circuit
Which of the following are commonly used as rectifiers in electrical circuits? - CORRECT
ANSWER- Diodes
Diodes are used in electrical power supply circuits primarily as - CORRECT ANSWER-
rectifiers
Transfer of electric energy from one circuit to another without the aid of electrical
connections - CORRECT ANSWER- is called induction
If three resistors of 3 ohms, 5 ohms, and 22 ohms are connected in series in a 28-volt circuit,
how much current will flow through the 3-ohm resistor? - CORRECT ANSWER- 0.93 amps
A circuit has an applied voltage of 30 volts and a load consisting of a 10-ohm resistor in
series with a 20-ohm resistor. What is the voltage drop across the 10-ohm resistor? -
CORRECT ANSWER- 10 Volts
Which is correct in reference to the electrical resistance? - CORRECT ANSWER- If one of
three bulbs in a parallel lighting circuit is removed, the total resistance of the circuit will
become greater
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller MGRADES. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $10.99. You're not tied to anything after your purchase.
