Exam (elaborations)
Electrical Questions and Answers 2024
- Course
- Institution
Exam of 16 pages for the course Enphase at Enphase (Electrical)
[Show more]
Content preview
ElectricalTechnician A says that a soldering gun must be energized for several minutes before it
warms up to the melting point of solder. Technician B says that a soldering torch is
heated by burning butane gas. Who is right? - answerB only
Which of the following is used to remove melted solder from an existing joint? - answer
Desoldering bulb
What does the term high impedance mean when applied to multimeters? - answerLow
current flow
Oscilloscopes are being discussed. Technician A says that an oscilloscope measures
changes in voltage. Technician B says that an oscilloscope measures changes in
speed. Who is right? - answerA only.
Timing lights are used to synchronize the operation of the engine ____. -
answercompression and ignition systems
The exhaust gas analyzer is installed in the vehicle tailpipe to measure which of the
following exhaust gas components? - answerChemical content
Computer memory retaining tools are being discussed. Technician A says that a small
battery is sufficient to maintain computer memory. Technician B says that the computer
memory retaining tool should be installed as soon as the battery is removed. Who is
right? - answerA only.
Technician A says that a battery tester can check the operation of the charging system.
Technician B says that a load tester can check the operation of the starting system.
Who is right? - answerB only.
Which of the following electrical sources is least likely to shock the technician? -
answerVehicle battery voltage
Technician A says that a blown fuse can be replaced with one with an amp rating no
more than 5 amps higher. Technician B says that a replacement wire should be the
same gage as the one being replaced. Who is right? - answerB only.
A shop fire approaches drums of flammable liquids, such as gasoline or cleaning fluid.
What should the technician do immediately? - answerLeave the shop.
,Batteries can explode because they give off what gas? - answerHydrogen
Which of the following fire extinguishers could be used to put out a gasoline fire? -
answerCarbon dioxide
Shop safety is being discussed. Technician A says that one way to prevent accidents is
to avoid people who are careless. Technician B says that one way to prevent accidents
is to keep the shop organized. Who is right? - answerBoth A and B.
A respirator is a type of ____ protection. - answerlung
Which of the following is not an electronic device? - answerSolenoid
Electronic devices usually operate using which of the following voltages? - answer6
volts or less
A sensor converts a condition such as pressure or flow into ____. - answerelectricity
Technician A says that modern voltage regulators control charging system voltage to
between 13 and 15 volts. Technician B says that voltage regulators on modern vehicles
are mounted at a cool spot on the engine firewall. Who is right? - answerA only.
The engine crankshaft turns the alternator rotor, usually through ____. - answera belt
and pulleys at the front of the engine
Technician A says that injector pulse width is an indication of how long the injector is
energized. Technician B says that injector pulse width is an indication of injection pump
fuel delivery. Who is right? - answerA only
In addition to seat belts, all of the following are supplemental restraint system
components, except: - answerMaster cylinder.
Technician A says that fuel injection is more efficient than carburetors in controlling air-
fuel ratio. Technician B says that a fuel-injected engine will produce more emissions
than a carbureted engine. Who is right? - answerA only.
Technician A says that all electrical problems are caused by something that decreases
current flow in a circuit. Technician B says that all electrical problems are caused by
something that decreases voltage in a circuit. Who is right? - answerA only.
Which of the following is not a way to systematically approach a problem? -
answerReplace the simplest or cheapest component first, then recheck.
A technician determines that none of the components in a particular circuit are working.
What should the technician do next? - answerBegin testing at the power source for the
circuit
, Technician A says that high circuit resistance could make a motor turn slowly and
overheat. Technician B says that high circuit resistance could make a bulb burn too
brightly and overheat. Who is right? - answerA only.
A circuit is shorted to ground between the circuit loads and the normal ground
connection. What will happen? - answerNothing will happen
A series circuit is shorted to ground between two lightbulbs in the circuit. What will
happen? - answerThe first lightbulb will light, but the second will stay off.
A loose connector could cause all of the following problems, except: - answerBlown
fuses.
Electrons have a(n) ____ charge. - answernegative
The building block for all matter is the ____. - answeratom
Which of the following is not a good insulator? - answerIron
Copper is a good conductor of electricity because two of its ____ are loosely attached to
their atom. - answerelectrons
Magnetism has an effect on materials containing which of the following? - answerIron
Current can be created in a wire by passing it through ____. - answera magnetic field
Which of the following is a measure of electrical pressure? - answerVoltage
Current flow is measured in which of the following units? - answerAmperes
One bulb in a series circuit of six bulbs burns out. What happens to the other bulbs in
the circuit? - answerThey will not light up.
What does a frame-ground circuit use as a return wire? - answerThe vehicle body or
frame
Technician A says in a series circuit, only some of the current flows through parts of the
circuit. Technician B says a series-parallel circuit is a combination of series and parallel
sections. Who is right? - answerB only.
Conventional and electronic current flow are being discussed. Technician A says that
conventional current flow is still used when discussing automotive electricity. Technician
B says conventional current flow is the correct way to describe electron flow. Who is
right? - answerA only.
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller Dreamer252. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $17.99. You're not tied to anything after your purchase.
Can Stuvia be trusted?
4.6 stars on Google & Trustpilot (+1000 reviews)
77254 documents were sold in the last 30 days
Founded in 2010, the go-to place to buy study notes for 14 years now