100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
CSLB B LICENSE GENERAL CONTRACTOR EXAM COMPLETE QUESTIONS AND ANSWERS $16.49   Add to cart

Exam (elaborations)

CSLB B LICENSE GENERAL CONTRACTOR EXAM COMPLETE QUESTIONS AND ANSWERS

 13 views  0 purchase
  • Course
  • CSLB CONTRACTOR\'S LAW & BUSINESS
  • Institution
  • CSLB CONTRACTOR\'S LAW & BUSINESS

CSLB B LICENSE GENERAL CONTRACTOR EXAM COMPLETE QUESTIONS AND ANSWERS

Preview 4 out of 32  pages

  • April 2, 2024
  • 32
  • 2023/2024
  • Exam (elaborations)
  • Questions & answers
  • CSLB CONTRACTOR'S LAW & BUSINESS
  • CSLB CONTRACTOR'S LAW & BUSINESS
avatar-seller
ElevatedExcellence
CSLB B LICENSE GENERAL
CONTRACTOR EXAM COMPLETE
QUESTIONS AND ANSWERS
If unused mortar stiffens due to hydration of cement, what must you do? CORRECT ANSWERS Discard the mortar
What minimum time must you wait before caulking or grouting new tiles? CORRECT ANSWERS 24-48 Hours
How long should you wait before installing tile on a shower pan? CORRECT ANSWERS
24 Hours
Unstable dry rock, angular gravel, sandy loam, and cohesive soils having compressive strengths greater than 0.5 and less than 1.5 tons/sq ft (tsf), are typical examples of: CORRECT ANSWERS Type-B Soils
If 65 street lights are fed by a 2275 volt series circuit, what is the voltage across each light? CORRECT ANSWERS 35V
In a series circuit, the total voltage is divided equally.
For safety reasons, the maximum simple slope of an excavation, up to 20 ft deep, in Type-B soil is: CORRECT ANSWERS 1:1 (45°)
A Pittsburgh joint is used in: CORRECT ANSWERS HVAC ductwork
The drain for a pressure relief valve on a water heater should be extended to: CORRECT ANSWERS The outside of the building
What is the minimum slope toward the drain of a shower pan? CORRECT ANSWERS 1/4" per foot (2%)
What is the diameter of #3 rebar? CORRECT ANSWERS 3/8"
If a vendor fails to provide an MSDS, you have the right to call: CORRECT ANSWERS Cal/OSHA or DOSH
When installing a door jamb, you need shims at: CORRECT ANSWERS Both hinge and
strike sides, three on each side.
Which of the following is used to adhere vinyl floors? A. Epoxy cement
B. Asphalt mastic
C. Latex primer
D. White glue CORRECT ANSWERS Epoxy cement
When do you need bracing for a drywall wall? CORRECT ANSWERS Diagonal bracing is needed every 25' for any drywall wall.
How should you clear the roots from a construction site? CORRECT ANSWERS Clear roots to 12" below grade.
Dividing watts by amps gives you: CORRECT ANSWERS Volts
The most frequent on-the-job roofing accidents are: CORRECT ANSWERS Falls
Which of the following is NOT a type of wood block flooring?
A. Parquet
B. Wood Mosaic
C. Wood Tile
D. All of the above. CORRECT ANSWERS Wood tile
Lightweight concrete is best used for:
A. Curb and Gutter
B. Second floor decking
C. First floor slab on grade
D. Footings CORRECT ANSWERS Second floor decking
The tool used to carry grout needed to patch a small hole is a:
A. Hawk
B. Poling board
C. Spot board
D. Mason's scutch CORRECT ANSWERS Spot Board
Which pipe is NOT appropriate for industrial wastes?
A. Cast iron
B. Schedule 40 ABS DWV
C. Extra strength vitrified clay
D. Copper CORRECT ANSWERS Copper
Where do you need a fire wall?
A. Between a living room and a bedroom B. Between a bedroom and a bathroom
C. Between a kitchen and a bath
D. A separation wall between a dwelling and an attachment CORRECT ANSWERS A separation wall between a dwelling and an attachment.
What is the minimum clearance between rough ground and untreated subfloor joists? CORRECT ANSWERS 18 inches
Who may remove asbestos? CORRECT ANSWERS Contractor with Asbestos Certification on license.
Which of the following is NOT likely to be found in significant proportions in granular soil?
A. Gravel
B. Sand
C. Silt
D. Clay CORRECT ANSWERS Clay
Stiles and rails are used on which of the following?
A. Furred walls
B. Roofs
C. Windows
D. Slabs CORRECT ANSWERS Windows.
A stile is the vertical edges of the window and the rails are the bottom and top.
What does a high slump test indicate? CORRECT ANSWERS Too much water.
Metal concrete forms should be?
A. Oiled
B. Watered
C. Placed against gravel
D. Discarded after each use CORRECT ANSWERS Oiled
What does the R mean in a description of insulation? CORRECT ANSWERS Resistance
What kind of door would you install for someone with a disability?
A. Automatic with minimum of 3 seconds to close
B. Automatic with maximum of 5 seconds to open
C. Manual with maximum of 8.5 pounds to operate
D. Either A or C CORRECT ANSWERS Either A or C Triple-walled metal chimney installations are regulated by: CORRECT ANSWERS ICC
ICC-IBC-IRC is the international code council. IBC is international building code commercial. IRC is the international residential code.
If you are a general contractor, you should call a specialty contractor when: CORRECT ANSWERS You encounter an unfamiliar trade.
When a stairway serves a public building, what is the minimum number of steps for which a handrail is required? CORRECT ANSWERS Two
What is the minimum underlayment for asphalt shingles? CORRECT ANSWERS 15 pounds
How long should you wait before sealing new tile work? CORRECT ANSWERS 2 weeks
When do you install insulation? CORRECT ANSWERS After the electrical and plumbing
are approved.
When do you NOT need an exhaust fan in a bathroom? CORRECT ANSWERS When there is a window in the bathroom.
What is a bush-hammer used for? CORRECT ANSWERS Roughen surface of hardened concrete.
When you say a wall is perfect it is: CORRECT ANSWERS Both plumb and straight.
The purpose of a batter board in concrete work is: CORRECT ANSWERS Support layout strings when location foundations.
What is the difference between a hip jack rafter and a common rafter? CORRECT ANSWERS A hip jack runs from the top plate to a hip rafter, but a common rafter runs to
the ridge board.
When should you float a concrete surface? CORRECT ANSWERS As soon as the water sheen evaporates
When installing drywall screws you should:
A. Countersink
B. Drive just below the face of the board
C. Leave slightly above the surface
D. Use the highest torque setting CORRECT ANSWERS Drive just below the face of the board without breaking the paper.

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller ElevatedExcellence. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for $16.49. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

75759 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy study notes for 14 years now

Start selling
$16.49
  • (0)
  Add to cart