100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
Home Inspection Exam Questions and Answers $12.49   Add to cart

Exam (elaborations)

Home Inspection Exam Questions and Answers

 30 views  0 purchase
  • Course
  • Home Inspection
  • Institution
  • Home Inspection

The preferred method for installing drip-edge flashing is _____________. - Answer- over the roofing paper/felt along the rake edge One of the main purposes of using crushed stone or gravel ballast on a built-up roof is to ________________. - Answer- protect the roof from sunlight A flat roof ...

[Show more]

Preview 3 out of 24  pages

  • June 22, 2023
  • 24
  • 2022/2023
  • Exam (elaborations)
  • Questions & answers
  • Home Inspection
  • Home Inspection
avatar-seller
Gordones22
Home Inspection Exam Questions and Answers
The preferred method for installing drip-edge flashing is _____________. - Answer- over the roofing paper/felt along the rake edge
One of the main purposes of using crushed stone or gravel ballast on a built-up roof is to ________________. - Answer- protect the roof from sunlight
A flat roof will usually have _____ installed. - Answer- internal drainage
_____ flashing will be found along the peak of the roof. - Answer- ridge
Slate tile roofs __________ be walked on. - Answer- should not
Modern bathroom receptacles are typically on _________ circuits. - Answer- 20 amp GFCI
____________ should not be used as a grounding means. - Answer- water pipes
Any GFCI breaker or receptacle that _____ should be written up as in need of immediate replacement. - Answer- fails to trip and reset properly
Ohms Laws are mathematical models that allows inspectors to understand why a 30-
amp fuse should not be connected to a 14-awg wire. T/F? - Answer- true
The minimum cable size for a service entrance for a 200-amp supply is ______________. - Answer- 2/0 copper or 4/0 aluminum
Wires to outlets are called __________. - Answer- branch circuit conductors
AFCIs (arc fault circuit interrupters) are _____ to protect bedroom circuits. - Answer- protect
_________ is defined as the flow of liquids in piping for a potable water distribution system in reverse of their intended path. - Answer- backflow
T/F: The design of a drainage system is based on uniform flow in the drainage piping. - Answer- true
__________ water heaters should not obtain combustion air from sleeping rooms, bathrooms or toilet rooms. - Answer- fuel-fired Glass doors enclosing the shower __________ made of safety glazing. - Answer- should be
The standpipe and trap for an automatic clothes washer should be at least ____ inches in diameter. - Answer- 2
Vent pipes that pass through a roof should end ______ 6 inches above the roof. - Answer- at least
In order to get good results in relation to observing water pressure at fixtures, it is good inspection procedural practice to inspect the plumbing fixtures at the ______ point in the
dwelling. - Answer- highest
Cleanouts for drainage pipes should be installed _____________ apart in horizontal drainage lines measured from the upstream entrance of the cleanout. - Answer- no more than 100 feet
An automatic clothes washer must discharge its wastewater through a(n) _________ into a standpipe or laundry tub. - Answer- air gap or air break
T/F: The purpose of the joist is to provide a nailing and support system for the floor sheathing and for the floor itself. - Answer- True
Modifications to a bearing wall ______________. - Answer- generally need to be designed and approved by a licensed professional engineer
A __________ is a space that is not a full basement and located between the ground and the bottom of the first floor of a home. - Answer- crawlspace
The first course of horizontal lumber placed on top of and attached to the foundation wall is known as the _____________. - Answer- sill plate
A _____ describes an assembly of three or four vertical studs nailed together to make up a corner framing element. - Answer- corner post
Inspecting the _______ potentially poses one of the riskiest, unsafe parts of a home inspection. - Answer- crawlspace
The ______ is installed at the intersection of roof rafters at their uppermost point. - Answer- ridge
When an opening must be made in a load-bearing wall, a _______ must be placed horizontally to help support the load. - Answer- header
While lifting a ladder, one should always _________. - Answer- lift with the leg muscles Doing tasks that require an awkward posture for more than one minute may contribute to ________. - Answer- a lower back injury
Dog bites are _________ common than cat bites, but cat bites are more likely to become infected. - Answer- less
A Type IA ladder supports a maximum of _______ pounds. - Answer- 300
T/F: Damaged ladders may still be used as long as they are properly labeled as to the extent of the damage identified. - Answer- False
Methane gas, which may be present in confined spaces such as a basement, can cause
death by __________. - Answer- asphyxiation
Wooden and fiberglass ladders ________________ protect a person from electrical shock. - Answer- don't always
Many inspection-related back injuries can be attributed to __________________ lifting and ladder-climbing techniques. - Answer- poor
One-person inspection businesses _______________. - Answer- should be especially diligent with regard to safety because no one is looking out for the inspector but himself/herself
A minimum service of _____ amps is required for a single residential dwelling unit. - Answer- 100
Proper _________ of a building site is important for preventing wet basements, damp crawlspaces, erosion, and possible failure of the foundation. - Answer- drainage
All 15- and 20-amp 120-volt circuits for dining rooms, living rooms, bedrooms, sun rooms, closets, hallways, and similar areas in a home must be ______ -protected. - Answer- AFCI
If particleboard is used as wall sheathing, the grade mark with Type _____ or _____ should be stamped on it. - Answer- M1 or M2
In high-wind installations, if an old composition asphalt shingle roof is going to be replaced, the roofing contractor should ___________ the existing shingles and underlayment. - Answer- remove
Standpipes for clothes washers should extend at least ____ inches and no more than ____ inches above the trap weir. - Answer- at least 18" and no more than 42"

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller Gordones22. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for $12.49. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

79223 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy study notes for 14 years now

Start selling
$12.49
  • (0)
  Add to cart