MWS TESTS COMPILATION BUNDLE

Identify TWO correct statements about conducting a daily inspection of an MWS apparatus equipped with a fire pump? correct answer: Confirm that the foam tank level is full. Operate the pump drive control When conducting a service test using a static water source, you must have____feet of hard...

The purpose of the priming device test is to: correct answer: Evaluate how quickly the priming device can create a vacuum to bring water through a pumpto the discharge hose. Identify TWO items that should be included on daily MWS apparatus records. correct answer: Coolant levels Traveling at...

During an MWS apparatus inspection, the lowest acceptable fuel gauge reading is: A. full B. at least 2/3 full C. at least 1/2 full D. at least 3/4 full correct answer: D. at least 3/4 full Most jurisdictions prefer to draft from a static water source during service testing because it: A...

Identify two correct statement about conducting a daily inspection of a MWS apparatus equipped with a fire pump correct answer: Confirm that the foam tank level is full Operate the pump drive control The purpose of the priming device test is to correct answer: Evaluate how quickly the priming d...

nfpa 1901 covers correct answer: fire apparatus nfpa 1901 says vehicles must put out what gal correct answer: 1500 to 3000 gal how many external mdh fill connections are needed correct answer: 1 mws equipped with correct answer: 1000 gal valve strainer and 30 degree elbow slow closin...

1. an MWS apparatus equipped with fire pump must have a tank to pump line at least 2 in in diameter and capable of supplying the pump with 500 GPM unit at least 80% of water in the tank is emptied 2. NMWS apparatus must be equipped with at least one external fuel connection connected into the tank ...

Identify FIVE requirements for a MWS apparatus that can be found in NFPA 1901 correct answer: 1. An MWS apparatus equipped with a fire pump must have a tank to pump line at least two inches in diameter and be capable of supplying the pump with 500 GPM until at least 80% of the tank is emptied. ...

IFSTA recommends water shuttle operations to use at least how many pumpers correct answer: Two Gravity dumps rely on what to empty water from the tank ? correct answer: Nature's gravitational pull Jet assisted dumps use what to empty tank ? correct answer: Use small diameter in line discha...

To be considered a MWS an apparatus must have at least _____ gallons correct answer: 1000 A MWS apparatus must be equipped with a min of ____ exterior fill connection allowing ____ Gpm full rate equipped with a ______, ______, & __ degree elbow which valve is slow closing if 3 inch or larger cor...

Venturi Effect correct answer: When fluid is forced under pressure through a restricted orifice, there is a decrease in the pressure exerted against the side of the constriction increase in the velocity of the fluid. Because the surrounding air is under greater pressure, it rushes into the area of ...

You're stationed in Alaska in December. You've just come back to find that your stall door isn't working and cannot be fixed until the next day. To prevent damage from freezing you should : correct answer: Drain rage piping, pump, and booster lines to prevent damage Identify three pieces of e...

Identify five reqiuremennts for an MWS app that can be found in NFPA1901 correct answer: visual/ operational checks and preventative maintenance Preservice pump certification tests are conducted by correct answer: An independent testing agency If the engine speed check proves the MWS app is ...

Which country is viewed as the absolute worst country for women due to rampant levels of domestic violence, rape, state-sanctioned physical abuse, child marriages, honor killings, and attacks on girls who dare to go to school or women who leave the home? correct answer: Afghanistan Which is NOT ...

What three factors are used to measure the efficiency of an MWS apparatus? correct answer: Filling Time Dumping Time Travel time between the dump and fill sites What are the two methods for determining a total flow rate for an individual MWS? correct answer: 1. Actual Testing 2. Formula Cal...