Automotive Bundled Exams [Chapter 1-10] Questions and Answers with Certified Solutions

Introduction to automobile Chapter 1 Already Passed What is the name of the automotive chassis design that has a floorpan and a small subframe section in the front and rear? Unibody design When air and fuel are compressed, the become very_______? Flammable The continuing up-and-down motion of the...

Automotive chapter 2 questions and answers 100% pass List four skills that may be needed when working as an automotive technician Computer technician, residential/commercial engineer, electronic engineer, tv radio technition What is a cooperative training program Combine classroom instructions with...

Automotive Chapter 3 Questions and Answers Graded A _____ or _____ maintained tools will hurt an automotive technician's on-the-job performance Greasy, oily Name three basic parts of a toolbox Large lower roll-around cabinet, upper tool chest, a small carrying tray A toolbox's ________ is for h...

Automotive chapter 4 quiz with Complete Solutions Power tools are tools that use Electricity hydraulics compressed air Which of the following is not a common impact wrench drive size? 3/8 1/4 1/2 3/4 1/4 Special impact sockets and extensions are easily identified because they are Flat black Each ...

Automotive: Chapter 4+5 Questions and Answers Already Passed What is used to support a vehicle after it has been raised? Jack Stand A cutting torch generates tremendous heat by burning________acetylene gas. Oxygen Technician A says that shop air pressure usually ranges from 100-150 PSI. Technician...

Auto-Chapter 5 Questions and Answers 100% Pass what does an auto shop's repair area normally include? Shop stall, lift, alignment rack, and outside work area A(n)____ is a small work area where a car can be parked for repairs. Shop stall List the rules that should be followed when using a lift As...

Automotive Chapter 6 Questions and Answers Graded A Which of the following is a common type of wrench used in the service of automobiles? All of the answers listed All of the following are variations on the open-end wrench, EXCEPT box-end wrench Sockets most commonly come in which of the following...

Automotive Services Chapter 6 Already Passed The 2 measuring systems are the...... System and ........ System Customary and Metric Which measuring system is used by most countries? Metric Our customary system originated from sizes taken from parts of the? Human body The metric system uses a power...

Automotive chapter 7 Questions and Answers 100% Pass visual voltmeter with a timer that shows when a voltage changed osciloscope uses a cathode ray tube similar to a tv screen analog scope takes samples of the signals that can be stopped or stored digital scope transparent scale used for referenc...

Automotive Chapter 8 Questions and Answers Parallel Circuit has more than one electrical path or leg. current the flow of electrons through a conductor atom small particles charged protons, neutrons, and electrons resistance the opposition to current flow relay an electrically operated switch i...

Automotive 1: Chapter 9 Questions and Answers Graded A A large repair facility recycles its used motor oil. Technician A says that only about one quart of high-quality oil can be recovered from each gallon of used oil that is recycled. Technician B says the recovery rate is about two and one-half q...

Automotive Chapter 10 Questions and Answers Rated A Vehicle fluids Engine oil, coolant, brake fluid, transmission fluid, power steering fluid, and other liquids Lubrication service 1. Checking fluid levels and conditions 2. Adding fluids as needed 3. Changing engine oil and filter 4. Changing autom...