BUNDLED NCIDQ EXAM STUDY QUESTIONS AND ANSWERS UPDATED 2024

To determine the necessary floor area for a project, the interior designer must know all the following EXPECT the A. Net assignable area B. Efficiency Factor C. Rentable-useable ratio D. Number of employees D. Number of employees The initial determination of the area required for a client's...

Why does the HVAC system need to be balanced at the end of a commercial project? A. To verify that air quality levels are within the design specifications B. To detect significant air leaks in the ductwork. C. To adjust airflow at each device location to meet the criteria in the engineer...

In regard to interior design, what is a guard, and what dimension must it have in commercial construction? -Correct Answer This is a building component installed to prevent falls from an elevated area. Its required minimum heights 42" AFF What is fire resistance-rated glazing? -Correct Answer ...

The minimum number of toilet fixtures for an interior design is determined by occupant load and? -Correct Answer Occupancy group Where are flame spread ratings in a building the MOST restrictive -Correct Answer Exit enclosures Exit access corridors in non-sprinklered buildings must have a rati...

Required fire rating of demising partition between tenant spaces -Answer- 1-hour Required fire rating of partitions along a public corridor -Answer- 1-hour Thresholds, if provided at doorways, shall be ___inch high maximum. -Answer- 1/2 inch maximum Doors opening from occupied spaces into t...

In wet areas, what are the requirements for wall finishes? -Correct Answer - walls within 2' or service sinks, toilets, or urinals are required to be constructed of moisture resistant material (cement board, X) and are required to have tile (or similar) finish up to minimum 4' AFF. Wallcoverin...

Where would it be best to call out the frame material on an entry door? A. door schedule B. finish schedule C. hardware schedule D. finish plan A: Door Schedule When would be most appropriate for an interior designer to use the prefix letter ‘I’ when numbering a set of construction drawing...